Frymaster Troubleshooting for Built-in Filtration System Issues

Page 46

6.2.4 Troubleshooting Built-in Filtration System

PUMP RUNS BUT DOES	PUMP RETURNS OIL TO
NOT RETURN OIL TO	FRYPOT VERY
FRYPOT.	SLOWLY.

Verify that filter pan is properly

seated in filter base, and that the oil return hose is not kinked or twisted.

Resume filtering.

Is oil

returning to Yes Problem resolved. frypot?

No

Verify that filter pan O-ring is

present and in good condition, and that recessed area in filter base is unobstructed. Resume filtering.

Check to see if filter paper (or pad) is heavily coated with crumbs. If so replace paper (or pad). Also verify the filter paper (or pad) is on top of the filter screen, not below it. Resume filtering.

Is oil

returning Yes Problem resolved. correctly?

No

Verify that filter pan is properly

seated in filter base, and that the oil return hose is not kinked or twisted.

Resume filtering.

Is oil	Yes	Problem resolved.	Is oil	Yes	Problem resolved.
returning to	Yes	Problem resolved.	returning	Yes	Problem resolved.
frypot?			correctly?
No			No
Probable cause is			Probable cause is
obstruction in tube on			obstruction in tube on
bottom of base.			bottom of base.

6-7

Image 46

Contents OPERATOR’S Manual Frymaster H52 Series GAS Fryer Page Introduction GeneralEuropean Community CE Specific Information Computer InformationWhat to do if your equipment arrives damaged Service Information Installation Instructions General Installation RequirementsNational Code Requirements Caster/Leg Installation Non-CE Standard For Incoming Gas Pressures Connection to Gas Line Countries Categories GASCE Standard Converting to Another Gas Type Gas VatCE Gas Conversion Kits for Units with Gas Valve Non-CE Gas Conversion KitsFrypot Boil-Out Operating Fryers With M100B Cooking Computers ShutdownIntroduction To The M-100B Cooking Computer DescriptionOperating the Computer on Full-Vat Fryers Operating the Computer on Split-Vat Fryers Viewing the Frypot Temperature Actual or SetpointCooking Product Full-Vat or Split-Vat M-100B Computer Problem Condition Indicators Recovery Out of Range REC LockOpen Drain Valve Indication Probe Failure Indication M-100B Computer Set-Up and Programming InstructionsHow to Change the Computer’s Display Language 1 M-100B Computer Setup ModeHow to Enter the Setup Mode How to Configure the Computer for Use on a Gas FryerHow to Change Computer Product/Temperature Displays How to Enter the Program Mode How to Activate or Deactivate the Frypot BOIL-OUT Feature2 M-100B Computer Programming Mode How to Reset the Computer to the Factory DefaultsHow to Change the Cooking Temperature Setpoint How to Enter a Product Name in a Test Menu How to Suppress a Shake, QA, or Duty Function How to Display Use Time Information How to Display the Product Cycle Accumulator InformationHow to Use the Filter Countdown Timer Operating Fryers With Analog Controllers Introduction to the Analog ControllerC D E F G H I J K L M N Analog Controller High-Limit Check Page Filtering Operating the Built-In Filtration System Page Operating the Filter Unit Page Getting the Most Out of Your Filter Page Preventive Maintenance Preventive Maintenance and TroubleshootingTroubleshooting Troubleshooting Fryers with M100B Computers REC LockIgnition Failure Display Remains Blank When ON/OFF Switches are Pressed Troubleshooting Fryers Equipped with Analog Controllers Did burners Troubleshooting Built-in Filtration System Pump does Not RUN