Frymaster H52 Series warranty 1 M-100B Computer Setup Mode, How to Enter the Setup Mode

Page 21

3.6.1 M-100B™ Computer Setup Mode

How to Enter the Setup Mode

1.Turn both sides of the computer OFF by pressing the switches. OFF will appear in both LED displays.

2.Press the right 1 , 2 and switches simultaneously.

3.Release all 3 switches at the same time. M100B, then SETUP will appear briefly in the left display, then BOIL-OUTwill appear in the left display and YES or NO will appear in the right display.

How to Change the Computer’s Display Language

1.Enter the setup mode. See How to Enter the Setup Mode above.

2.Press and release the switch until the word language appears in the left LED display.

3.Press the right 1 or 2 switch until the desired language (English, French, French-Canadian, Spanish, or Portuguese) is displayed in the right LED display.

4.When the desired language is displayed, press either ON/OFF switch to lock in the selection. The right display will show loading for about 5 seconds, indicating that the computer’s display language is being changed, then both displays will change to OFF.

How to Configure the Computer for Use on a Gas Fryer

1.Enter the setup mode. See How to Enter the Setup Mode above.

2.Press and release the switch until GAS Yes or GAS no appears in the LED displays.

3.Gas nO indicates the computer is configured for use on an electric fryer; Gas YES indicates the computer is configured for use on a gas fryer. Press the right 1 or 2 switch to change the configuration.

3–8

Image 21

Contents OPERATOR’S Manual Frymaster H52 Series GAS Fryer Page General IntroductionComputer Information European Community CE Specific InformationWhat to do if your equipment arrives damaged Service Information General Installation Requirements Installation InstructionsNational Code Requirements Caster/Leg Installation Non-CE Standard For Incoming Gas Pressures Countries Categories GAS Connection to Gas LineCE Standard Gas Vat Converting to Another Gas TypeNon-CE Gas Conversion Kits CE Gas Conversion Kits for Units with Gas ValveFrypot Boil-Out Shutdown Operating Fryers With M100B Cooking ComputersDescription Introduction To The M-100B Cooking ComputerOperating the Computer on Full-Vat Fryers Viewing the Frypot Temperature Actual or Setpoint Operating the Computer on Split-Vat FryersCooking Product Full-Vat or Split-Vat Recovery Out of Range REC Lock M-100B Computer Problem Condition IndicatorsOpen Drain Valve Indication M-100B Computer Set-Up and Programming Instructions Probe Failure IndicationHow to Enter the Setup Mode 1 M-100B Computer Setup ModeHow to Change the Computer’s Display Language How to Configure the Computer for Use on a Gas FryerHow to Change Computer Product/Temperature Displays 2 M-100B Computer Programming Mode How to Activate or Deactivate the Frypot BOIL-OUT FeatureHow to Enter the Program Mode How to Reset the Computer to the Factory DefaultsHow to Change the Cooking Temperature Setpoint How to Enter a Product Name in a Test Menu How to Suppress a Shake, QA, or Duty Function How to Display the Product Cycle Accumulator Information How to Display Use Time InformationHow to Use the Filter Countdown Timer Introduction to the Analog Controller Operating Fryers With Analog ControllersC D E F G H I J K L M N Analog Controller High-Limit Check Page Filtering Operating the Built-In Filtration System Page Operating the Filter Unit Page Getting the Most Out of Your Filter Page Preventive Maintenance and Troubleshooting Preventive MaintenanceTroubleshooting REC Lock Troubleshooting Fryers with M100B ComputersIgnition Failure Display Remains Blank When ON/OFF Switches are Pressed Troubleshooting Fryers Equipped with Analog Controllers Did burners Troubleshooting Built-in Filtration System Pump does Not RUN