Frymaster H52 Series warranty Did burners

Page 45

BURNERS DO NOT

LIGHT

(POWER LIGHT ON,

HEAT LIGHT ON,

TROUBLE LIGHT ON)

Verify that all drain valves are fully closed. Verify the main gas valve is open and the gas valve knob (non- CE units) is ON. Place power swtiches in OFF position, then back ON.

	Did burners	Yes	Problem resolved.
	light?

No

Place power switches in OFF

position. Disconnect and reconnect the flexible gas line quick-disconnect fitting. Place power switches in ON position.

	Did burners	Yes	Problem resolved.
	light?

No

Place power switches in OFF

position. Verify that combustion air blower inlet is open and that blower is clean. Place power switches in ON position.

	No
	Did burners	Yes	Problem resolved.
	light?	Yes	Problem resolved.
	light?

No

Problem is beyond scope of operator troubleshooting. Call

FASC

6-6

FRYER FAILS 2ND

HIGH-LIMIT TEST

(HEAT LIGHT ON, 2ND HI-LIMIT LIGHT OFF, AND FRYER CONTINUES TO HEAT IN 2ND HI-LIMIT TEST POSITION.)

Probable cause is a defective high-

limit thermostat. Call FASC.

Image 45

Contents OPERATOR’S Manual Frymaster H52 Series GAS Fryer Page General IntroductionComputer Information European Community CE Specific InformationWhat to do if your equipment arrives damaged Service Information General Installation Requirements Installation InstructionsNational Code Requirements Caster/Leg Installation Non-CE Standard For Incoming Gas Pressures Countries Categories GAS Connection to Gas LineCE Standard Gas Vat Converting to Another Gas TypeNon-CE Gas Conversion Kits CE Gas Conversion Kits for Units with Gas ValveFrypot Boil-Out Shutdown Operating Fryers With M100B Cooking ComputersDescription Introduction To The M-100B Cooking ComputerOperating the Computer on Full-Vat Fryers Viewing the Frypot Temperature Actual or Setpoint Operating the Computer on Split-Vat FryersCooking Product Full-Vat or Split-Vat Recovery Out of Range REC Lock M-100B Computer Problem Condition IndicatorsOpen Drain Valve Indication M-100B Computer Set-Up and Programming Instructions Probe Failure IndicationHow to Enter the Setup Mode 1 M-100B Computer Setup ModeHow to Change the Computer’s Display Language How to Configure the Computer for Use on a Gas FryerHow to Change Computer Product/Temperature Displays 2 M-100B Computer Programming Mode How to Activate or Deactivate the Frypot BOIL-OUT FeatureHow to Enter the Program Mode How to Reset the Computer to the Factory DefaultsHow to Change the Cooking Temperature Setpoint How to Enter a Product Name in a Test Menu How to Suppress a Shake, QA, or Duty Function How to Display the Product Cycle Accumulator Information How to Display Use Time InformationHow to Use the Filter Countdown Timer Introduction to the Analog Controller Operating Fryers With Analog ControllersC D E F G H I J K L M N Analog Controller High-Limit Check Page Filtering Operating the Built-In Filtration System Page Operating the Filter Unit Page Getting the Most Out of Your Filter Page Preventive Maintenance and Troubleshooting Preventive MaintenanceTroubleshooting REC Lock Troubleshooting Fryers with M100B ComputersIgnition Failure Display Remains Blank When ON/OFF Switches are Pressed Troubleshooting Fryers Equipped with Analog Controllers Did burners Troubleshooting Built-in Filtration System Pump does Not RUN