Frymaster H52 Series warranty Troubleshooting Fryers Equipped with Analog Controllers

Page 44

6.2.3 Troubleshooting Fryers Equipped with Analog Controllers

FRYER OPERATES

PROPERLY BUT "POPS" WHEN BURNERS LIGHT.

Place power switches in OFF

position. Verify that combustion air

blower shutter is open and that blower is clean. Place power switches in ON position.

POWER LIGHT ON,

TROUBLE LIGHT ON,

HEAT LIGHT OFF,

BURNERS DO NOT

LIGHT.

Place power switches in OFF position. Swap controller with another known to be working. Place power switches ON.

	Did popping	Yes	Problem resolved.
	cease?

No

Problem is beyond scope of operator troubleshooting. Call

FASC

POWER SWITCH ON,

BUT NO CONTROLLER

LIGHTS ARE LIT.

Verify that power cord is plugged into live circuit, fryer circuit breaker is not tripped, and hood circuit breaker is not tripped..

If above conditions are correct,

Does

fryer operate Yes correctly?

No

Probable causes are loose or broken wiring connections.

Call FASC.

FRYER IS OPERATING

NORMALLY, BUT

RECOVERY IS SLOW

WHEN COOKING.

Place power switches in OFF

position. Verify that combustion air blower shutter is properly adjusted and that blower is clean. Place power switches in ON position.

Defective controller.

Replace.

probable causes are failed

transformer or failed controller. Call

FASC.

	Is recovery	Yes	Problem resolved.
	time correct?

No

Probable cause is low or fluctuating

gas pressure. Call FASC.

6-5

Image 44

Contents OPERATOR’S Manual Frymaster H52 Series GAS Fryer Page Introduction GeneralWhat to do if your equipment arrives damaged Computer InformationEuropean Community CE Specific Information Service Information Installation Instructions General Installation RequirementsNational Code Requirements Caster/Leg Installation Non-CE Standard For Incoming Gas Pressures Connection to Gas Line Countries Categories GASCE Standard Converting to Another Gas Type Gas VatFrypot Boil-Out Non-CE Gas Conversion KitsCE Gas Conversion Kits for Units with Gas Valve Operating Fryers With M100B Cooking Computers ShutdownIntroduction To The M-100B Cooking Computer DescriptionOperating the Computer on Full-Vat Fryers Cooking Product Full-Vat or Split-Vat Viewing the Frypot Temperature Actual or SetpointOperating the Computer on Split-Vat Fryers M-100B Computer Problem Condition Indicators Recovery Out of Range REC LockOpen Drain Valve Indication Probe Failure Indication M-100B Computer Set-Up and Programming Instructions1 M-100B Computer Setup Mode How to Enter the Setup ModeHow to Change the Computer’s Display Language How to Configure the Computer for Use on a Gas FryerHow to Change Computer Product/Temperature Displays How to Activate or Deactivate the Frypot BOIL-OUT Feature 2 M-100B Computer Programming ModeHow to Enter the Program Mode How to Reset the Computer to the Factory DefaultsHow to Change the Cooking Temperature Setpoint How to Enter a Product Name in a Test Menu How to Suppress a Shake, QA, or Duty Function How to Display Use Time Information How to Display the Product Cycle Accumulator InformationHow to Use the Filter Countdown Timer Operating Fryers With Analog Controllers Introduction to the Analog ControllerC D E F G H I J K L M N Analog Controller High-Limit Check Page Filtering Operating the Built-In Filtration System Page Operating the Filter Unit Page Getting the Most Out of Your Filter Page Troubleshooting Preventive Maintenance and TroubleshootingPreventive Maintenance Troubleshooting Fryers with M100B Computers REC LockIgnition Failure Display Remains Blank When ON/OFF Switches are Pressed Troubleshooting Fryers Equipped with Analog Controllers Did burners Troubleshooting Built-in Filtration System Pump does Not RUN