Jenn-Air JJW3430 manual Oven USE, Aluminum Foil, Positioning Racks and Bakeware, Roll-Out Rack

Reset All Settings To Factory Defaults

1.From the Setup Menu, touch the button at the right-hand side of screen beside Reset All Settings to Factory Default.

2.Touch RESET or CANCEL.

3.If Reset is touched, the following settings will be lost: most used modes/foods, My Creations, Date/Time, and Language. The Welcome Guide will appear to help you reset these settings.

Service Information

For more information, see the “Assistance or Service” section.

1.From the Setup menu, touch the button at right-hand side of screen beside Service Information.

2.Choose ON or OFF for Demo Mode. When Demo Mode is On, the oven will not heat and "Demo Mode" will appear on the left side of the screen.

3.If CANCEL is touched, the Service Information will go back to the default setting.

4.Touch SAVE. This will return you to the Clock screen.

OVEN USE

Odors and smoke are normal when the oven is used the first few times, or when it is heavily soiled.

During oven use, the heating elements will not remain on, but will cycle on and off throughout oven operation.

IMPORTANT: The health of some birds is extremely sensitive to the fumes given off. Exposure to the fumes may result in death to certain birds. Always move birds to another closed and well- ventilated room.

Aluminum Foil

IMPORTANT: To avoid permanent damage to the oven bottom finish, do not line the oven bottom with any type of foil or liner.

■For best cooking results, do not cover entire rack with foil because air must be able to move freely.

■To catch spills, place foil on rack below dish. Make sure foil is at least ½" (1.3 cm) larger than the dish and that it is turned up at the edges.

Positioning Racks and Bakeware

IMPORTANT: To avoid permanent damage to the porcelain finish, do not place food or bakeware directly on the oven door or bottom.

RACKS

■Position racks before turning on the oven.

■Do not position racks with bakeware on them.

■Make sure racks are level.

Depending on the oven model, you could have flat, offset and/or roll-out racks. If “f” is after the rack position, the flat rack should be used. An “o” after the rack position indicates the offset rack should be used. An “r” indicates the roll-out rack should be used. For example: 1o, 3f, 5r indicates the use of the offset rack in rack position 1, the flat rack in position 3, and the roll-out rack in position 5. Refer to the section for the mode you are using for specific rack recommendations.

5

4

3

2

1

BAKEWARE

To cook food evenly, hot air must be able to circulate. Allow 2" (5.0 cm) of space around bakeware and oven walls.

Roll-Out Rack

The roll-out rack allows easy access to position and remove food in the oven. The roll-out rack will fit in all positions.

Open Position

A

B

A. Slide rails

B. Sliding shelf

Closed and Engaged Position

A

B

A. Slide rails

B. Sliding shelf

To Insert Roll-Out Rack

1.Angle rack assembly up and insert into the “V” cutout in the rack guides of the oven cavity.

2.Keep rack lifted up at an angle and push in to bypass the lower “V” cutout.

3.Gently slide rack into oven, bypassing the “V” cutouts.

A

B

A.Rack guide

B.“V” cutout

11