Jenn-Air 8113P714-60 Surface Cooking, Surface Controls, Suggested Heat Settings

Page 13
SURFACE COOKING

SURFACE COOKING

Surface Controls

Surface Controls CAUTION

If flame should go out during a cooking operation and the burner does not reignite itself, turn the burner off. If a strong gas odor is detected, open a window and wait five minutes before relighting the burner.

Be sure all surface controls are set in the OFF position prior to supplying gas to the range.

NEVER touch cooktop until it has cooled. Expect some parts of the cooktop, especially around the burners, to become warm or hot during cooking. Use potholders to protect hands.

Suggested Heat Settings

Pilotless Ignition

Pilotless ignition eliminates the need for a constant standing pilot light. Each surface burner has a spark ignitor. Use care when cleaning around the surface burner.

If the surface burner does not light, check if ignitor is broken, soiled or wet.

Surface Control Knobs

Use to turn on the surface burners. An infinite choice of heat settings is available from Lo to Hi. At the Hi setting a detent or notch may be felt. The knobs can be set on or between any

The size and type of cookware, type and amount of food and BTU of the burner will determine where to set the knob Suggested Heat Settings for cooking operations. Use the settings printed around the knobs Pilotless Ignition as a guide.The following

descriptions will aid in choosing the type setting that will gived optimum results:

Hold or Warm: Food maintains a temperature above 140° F without continuing to cook. Food is heated on a higher flame size until it reaches this temperature and then the flame size is reduced. Never use a hold or warm setting to reheat cold food. Be sure knob is adjusted to produce a stable flame. (Use the Lo setting or the simmer burner located at the right rear to keep food warm.)

Style of knob

varies by model.

of the settings.

Graphics next to the knob identify which burner the knob controls. For example, the graphic at left shows the right front burner location (Style of graphic varies by model.).

Setting the controls:

The size and type of cookware will affect the heat setting.

1.Place a pan on the burner grate.

The burner flame may lift off or appear separated from the port if a pan is not placed on the grate.

2.Push in and turn the knob to the desired setting.

A clicking (spark) sound will be heard and the burner will light.

Important: Each surface burner is equipped to provide automatic reignition if the flame should somehow get blown out.

Simmer: Food forms bubbles that barely break the surface. Foods are between 185° F and 200° F. A simmer setting can also be used to steam or poach foods or continue cooking covered foods. (Adjust the knob between Hi and Lo to obtain the desired simmer action.)

Slow Boil: Food forms bubbles at a moderate pace. A slow boil setting can also be used for most frying and for maintaining the cooking of large amounts of liquids. (Adjust the knob between Hi and Lo to obtain the desired boil action.)

Boil: Liquid forms bubbles at a rapid pace. A fast boil setting can be used to bring liquid to a boil, brown meat, stir fry, saute, and heat oil for frying before turning to a lower setting. The HIGH setting is always used to bring liquids to a boil. Once the liquid boils, always reduce the flame size to the lowest setting that will maintain the boil action. (Turn the knob to Hi then adjust the flame size to fit the size of the pan.)

Operating During a

Power Failure

Surface Control Knobs CAUTION

When lighting the surface burners, be sure all of the controls are in the OFF position. Strike the match first and hold it in position before turning the knob on.

1.Hold a lighted match to the desired surface burner head.

2.Push in and turn the control knob slowly on.

3.Adjust the flame to the desired level.

12

Image 13
Contents USE & CARE GUIDE TABLE OF CONTENTSJENN-AIR GAS RANGE General Instructions Recognize Safety Symbols, Words, LabelsIMPORTANT SAFETY INSTRUCTIONS To Prevent Fire or Smoke Damage Child SafetyIn Case of Fire About Your ApplianceUtensil Safety Cooking SafetySelf-Clean Oven Cleaning SafetyImportant Safety Notice and Warning Deep Fat FryersBefore Self-Cleaning CARE & CLEANINGTo set Self-Clean To Delay a Self-Clean CycleAfter Self-Cleaning Cleaning ProceduresPROCEDURE PARTDO NOT USE ABRASIVE OR ORANGE CLEANERS DO NOT USE ANY CLEANING PRODUCT CONTAINING CHLORINE BLEACHALWAYS WIPE WITH THE GRAIN WHEN CLEANING white surfacesOven Door MAINTENANCEOven Window Leveling LegsRemoval of Gas Appliance Electrical ConnectionAlways disconnect power to appliance before servicing PROBLEM TROUBLESHOOTINGSOLUTION detected, the message FAULT DETECTED - PRESS POWER TO CLEAR or FAULT Operating During a Power Failure Suggested Heat SettingsSetting the controls SURFACE COOKINGLow Turn Down Burner CooktopSealed Burners High Performance BurnerOVEN COOKING Setting the ClockControl Panel Pilotless Ignition select modelsLocking the Control and Oven Door TimersBake Options BakingTo set Bake To set Cook & HoldConvect Options Convect select modelsRapid Preheat select models Convect Bake select modelsConvect Roast select models BroilTo set Convect Roast To set BroilOven Fan Broiling ChartOven Vent Oven BottomRack Positions Oven RacksBaking Layer Cakes on Two Racks OPTIONS To set Delay CleanMore Options DelayThaw and Serve select models Thaw and Serve ChartKeep Warm To set Thaw-ServeDrying select models To Warm PlatesTo set Drying Wash, peel if desired, core and slice Drying Guide select modelsWash, peel and remove thorny eyes Halve, remove seeds. Place tomatoesFAVORITES To select a recipe from the preset Recipe ListFavorites To Save the Last Recipe CompletedSetup SETUPLanguage Auto Convect Conversion select modelsTo adjust the oven temperature Temp AdjustTo cancel Sabbath Mode To adjust the beepsTo change the volume of the beeps ServiceTo turn off this feature To set the Energy Saver featureLIMITED WARRANTY JENN-AIR COOKING APPLIANCE WARRANTYSECOND THROUGH FIFTH YEAR LIMITED WARRANTY ON CERTAIN COMPONENT PARTS ITEMS EXCLUDED FROM WARRANTY This limited warranty does not coverCUISINIÈRE À GAZ JENN-AIR GUIDE D’UTILISATION ET D’ENTRETIENTABLE DES MATIÈRES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES Reconnaissez les étiquettes, paragraphes et symboles sur la sécuritéInstructions générales AVERTISSEMENTEn cas d’incendie Pour éviter un incendie ou des dommages causés par la fuméeSécurité des enfants Familiarisation avec l’appareilUstensiles et sécurité Cuisson et sécuritéHottes d’extraction FriteusesNettoyage et sécurité Four autonettoyantAvant l’autonettoyage ENTRETIEN ET NETTOYAGEProgrammation de l’autonettoyage Pour différer l’autonettoyageAprès l’autonettoyage Techniques de nettoyageRemarques PIÈCEest particulièrement important dans le cas de surfaces blanches directement sur les touches de commande et l’afficheurN’UTILISEZ PAS DE NETTOYANTS ABRASIFS OU À BASE D’ORANGE ESSUYEZ TOUJOURS DANS LE SENS DU GRAIN PENDANT LE NETTOYAGEPorte du four ENTRETIENLampe du four Hublot du fourRaccordement électrique Déplacement d’un appareil à gazToujours débranchez l’appareil avant d’y faire de l’entretien PROBLÈME DÉPANNAGEDéterminez si l’appareil a été programmé pour un autonettoyage différé. Voyez la page CUISSON SUR LA SURFACE Commandes de la surface de cuissonAllumage sans flamme de veille Réglages suggérés de la puissance de chauffageBrûleurs scellés Surface de cuissonBrûleurs de haute Brûleur de faible puissanceCUISSON AU FOUR Tableau de commandeTouches rapides Allumage sans flamme de veillePour verrouiller les commandes et la porte du four Verrouillage des commandes et de la porte du fourMinuteries Pour activer et annuler l’affichage de l’horloge/jour de la semaineCuisson au four Pour déverrouiller les commandes et la porte du fourOptions de cuisson au four Programmation de la cuisson au fourConvection certains modèles Cuisson à convectionOptions de convection Rapid Preheat Préchauffage rapide certains modèlesCuisson au gril Convect Roast Rôtissage àconvection certains modèles Pour retourner au préchauffage standardÉvent du four Ventilateur du fourSole du four Tableau de cuisson au grilPositions des grilles Grilles de fourCuisson de gâteaux à étages sur deux grilles Grille 6 Utilisée pour laCuisson et maintien certains modèles Autres optionsDémarrage différé Programmation de la cuisson différéeMaintien au chaud Décongeler et servir certains modèlesTableau de la fonction Décongeler et servir Programmation de la fonction Décongeler et servirPour réchauffer des assiettes Pour réchauffer des petits painsDeshydration certains modèles Programmation de la dessiccationGuide de deshydration certains modèles Réglage favori RÉGLAGE FAVORIPour sélectionner une recette de la liste préétablie Pour sauvegarder la dernière recette complétéeRéglage RÉGLAGELangue Pour supprimer une recette favoriteMode sabbat Ajustement de la températureSignaux sonores bips Pour ajuster la température du fourPour modifier le volume des bips Service à la clientèleArrêt automatique 12 heures Économie d’énergieGARANTIE LIMITÉE GARANTIE DES APPAREILS DE CUISSON JENN-AIRARTICLES EXCLUS DE LA GARANTIE La présente garantie limitée ne couvre pasESTUFA A GAS JENN-AIR GUÍA DE USO Y CUIDADOTABLA DE CONTENIDO Cuidado y limpiezaInstrucciones generales INSTRUCCIONES IMPORTANTES SOBRE SEGURIDADReconozca los símbolos, advertencias y etiquetas de seguridad ADVERTENCIAPara evitar daños a causa de un incendio o humo Instrucciones generalEn caso de incendio Seguridad para los niñosInformación de seguridad sobre la cocción Información sobre su electrodomésticoOllas freidoras Información de seguridad sobre los utensiliosCampanas de ventilación Información de seguridad sobre la limpiezaConserve estas instrucciones para referencia futura Aviso y adverntencia importantes de seguridadAntes de la autolimpieza CUIDADO Y LIMPIEZAPara programar la autolimpieza Para diferir un ciclo de autolimpiezaDespués de la autolimpieza Procedimientos de limpiezaNotas PIEZAes especialmente importante para las superficies blancas área de las teclas de control y de la pantallaNO USE LIMPIADORES ABRASIVOS O DE NARANJA SIEMPRE LIMPIE LAS SUPERFICIES DE ACERO A FAVOR DEL GRANOPuerta del horno MANTENIMIENTOLuz del Horno Ventanilla del hornoDesinstalación de un electrodoméstico a gas Conexión eléctricaPara volver a instalar Siempre desenchufe el electrodoméstico antes de realizar reparacionesLOCALIZACIÓN Y SOLUCIÓN DE AVERÍAS PROBLEMASOLUCIÓN leve cuando se enciende el horno Controles superiores COCCIÓN EN LA CUBIERTAEncendido sin piloto Ajustes de calor sugeridosQuemadores sellados CubiertaQuemador de alto rendimiento Quemador de nivel bajoPanel de Control COCCIÓN EN EL HORNOEncendido Sin Piloto modelos selectos RelojBloqueo del control y de la puerta del horno “Timers” TemporizadoresOpciones de horneado HorneadoPara hornear Para programar la función “Cook & Hold” Cocinar y mantener caliente“Convect” Convección modelos selectos “Convect Bake” Horneado porOpciones de convección modelos selectos convección modelos selectos“Broil” Asar “Convect Roast” Asado porPara asar por convección Para asar a la parrillaRespiradero del horno Ventilador del hornoLuz del horno Parte inferior del hornoPosiciones de las parrillas Parrillas del hornoHorneado de pasteles de capas en dos parrillas Más opciones OPCIONES“Delay” Diferir “Cook & Hold” Cocinar y mantener caliente modelos selectos“Thaw and Serve” Descongelar y servir modelos selectos Tabla para descongelar y servirPara programar la función descongelar y servir “Keep Warm” Mantener calientePara calentar platos Para calentar panecillos“Drying” Secado modelos selectos Para programar el secadoGuía de secado modelos selectos “Favorites” Favoritos FAVORITOSPara seleccionar una receta de la lista de recetas preprogramadas Para guardar la última receta terminadaAJUSTE “Setup” Ajuste“Clock” Reloj IdiomaModo sabático “Temp Adjust” Ajuste de la temperaturaPara cambiar la escala Para activar el modo sabáticoPara cambiar el volumen de las señales sonoras “Service” ServicioTonos Bips Para ajustar las señales sonorasNOTAS GARANTÍA LIMITADA DE UN AÑO GARANTÍA DE LOS APARATOS DE COCCIÓN DE JENN-AIREXCLUSIONES DE LA GARANTÍA Esta garantía limitada no cubre EXCLUSIÓN DE GARANTÍAS IMPLÍCITAS LIMITACIÓN DE RECURSOS