Description SJ, Before the first use, Assembling

Description (SJ 600)

1Juicer drum

2Fine grating disc

3 Strainer basket

4 Cover

5 Filling tube

6 Pusher

Before the first use

After unpacking the appliance, please disassemble it and clean all parts. To disassemble the appliance proceed as follows:

•Unlock the strainer basket 3 by turning it clockwise (a) and wash all parts by hand.

•Pull the key in the bottom of the juicer drum 1 as far as it will go (b).

•Turn the juicer drum 1 anti-clockwise with the key in the bottom of the juicer drum pulled (b) – until the fine grating disc 2 is unlocked.

•Then pull the fine grating disc 2 by its shaft out of the juicer drum 1 (c).

Assembling

•Attach the food processor bowl of your Braun Multiquick (without the blade) to the motor block and lock it in place.

For grating:

• Use the fine grating disc 2 only (e).

For juice extracting:

•Insert the fine grating disc 2 into the juicer drum 1 so that the cut-out sections in the rim of the fine grating disc slide over the holding studs in the juicer drum (d).

•Push the fine grating disc 2 by its shaft slightly down and turn it clock wise until it clicks in (d).

•Check by trying to turn the shaft of the fine grating disc 2 whether the grating disc is properly locked. If it is, the shaft cannot be turned.

•Insert the strainer basket 3 into the juicer drum 1, and ensure that both tabs fit into the notches of the drum (f).

•For juice extracting set the assembled juice extractor on the food processor bowl drive shaft of your Braun Multiquick. If you want to grate, set the fine grating disc 2 only on the drive shaft of the food processor bowl.

•Place the cover 4 on the Braun Multiquick food processor bowl so that the arrow on the cover matches the arrow on the food processor bowl.

Then turn the cover clockwise until the nozzle on the cover is in the safety lock on the motor block of your Braun Multiquick system and audibly snaps into place (g). To remove, turn the cover anti-clockwise.

Extracting juice

Maximum capacity: 500 g or when the pulp space is full. You can extract juice from fruits, as well as from vegetables.

•Preparing fruits or vegetables: First wash or peel the food. Fruits with pits should always have the pits removed first. Citrus fruits, as well as fruits with skin and vegetables (e.g. red beets and Kiwi-fruits) should be thor oughly peeled. Seed fruits (e.g. apples) can be processed with peels and cores.

•Speed selection:

Please select the setting 7–8 on your Braun Multiquick.

•Extracting:

Turn on the motor of your Braun

Multiquick. Fill the prepared fruits or vegetables into the filling tube 5 and push it down with the pusher 6 (h).

Caution: Always use the pusher. Never reach into the filling tube while the motor is running!

Do not overload the appliance.

•Disassembling:

Turn off the motor of your Braun Multiquick. Turn the cover 4 anti- clockwise and remove it from the food processor bowl. Then proceed as described in the section «Before the first use». Remove all parts from the food processor bowl of your Braun Multiquick. If the fruit pulp is very dense, pull the disengaged strainer basket 3 out of the juicer drum 1 by using the pull rings (f).

Grating

The fine grating device is designed for very fine grating of food such as hard cheese (e.g. Italian parmigiano cheese or Swiss sprintz cheese), horse-radish (e.g. for horse-radish cream), apples and carrots (e.g. for baby food).

Important: The fine grating disc is not suited for grating chocolate.

•Preparing the food for grating: Fruits and vegetables should be washed first or peeled. Seeds and cores should be removed. Cut off the crust from cheese. The food should be cut small enough to fit into the filling tube 5.

•Speed selection:

Please select the setting 7–15 on your Braun Multiquick.

Note: Hard food should be grated at higher speeds.

•Grating:

Turn on the motor of your Braun

Multiquick. Fill the prepared food into the filling tube 5 and push it down with the pusher 6 (h).

Caution: Always use the pusher. Never reach into the filling tube while the motor is running!

•Disassembling:

Turn off the motor of your Braun Multiquick. Turn the cover 4 anti-clock wise and remove it from the food pro cessor bowl. Then remove the fine grat ing disc 2 from the food processor bowl.

Cleaning

All parts can be cleaned in the dish washer at temperatures up to 65 °C. Pulp and other residues should not become dry before the appliance is cleaned. The appliance may discolour when processing food with high degree of pigments (e.g. carrots); use vegetable oil to clean it, before cleaning with detergents or in the dishwasher.

Please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country.

Subject to change without notice.