English
Our products are engineered to meet the highest standards of quality, functionality and design. We hope you thoroughly enjoy your new Braun appliance.
The Braun K 3000 is a kitchen machine system which fulfils highest demands for kneading, mixing, stirring, whipping, chopping, slicing, shredding and grating, simply and quickly.
Read all instructions carefully before using this product.
Important
•The blades o and s are very 
sharp!
Take hold of the blades by the knob only. After use, always first remove the blade from the bowl before removing the processes food.
•This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach
of children. Children should be supervised to ensure that they do not play with the appliance.
•This appliance was constructed for household use only to process the listed quantities.
•Do not use any part in the microwave oven.
•Do not allow the appliance to operate unsupervised.
•Braun electric appliances meet applicable safety standards. Repairs or the replace- ment of the mains cord must only be done by authorised service personnel. Faulty, unqualified repair work may cause considerable hazards to the user.
•Switch the appliance off and disconnect from the mains before storing.
ABasic unit (see page 4)
1Motor block
2 Cord store
3 Control lamp for safety fuse
4 Motor switch (constant operation/ on: «I», off: «O»,
automatic pulse: «•• ••»)
5Press button for manual pulse
6 Electronic speed regulator (variable 1
7 Kneading attachment
8 Drive arm
H Mixing attachment h Whisk attachment 9 Spatula
j Filling tube 11 Lid
l Dough bowl (stainless steel)
Safety fuse
The control lamp 3 flashes to indicate that the motor is overloaded and will soon switch off. As soon as the safety fuse has switched off the motor, the control lamp 3 is constantly lit up. Turn the appliance off with the motor switch 4 (switch position «O»). Wait approximately
15 minutes to allow the motor to cool off. Then
switch the appliance on again using the motor switch 4(position «I/on»). If the control lamp 3 should light up again and the motor does not start, repeat the cooling procedure as described above.
Important: lf the motor has automatically switched itself off because of an overload, the appliance can only be switched back on with the motor switch 4 if it had been switched off (position «O») with this switch before.
Speed regulator
It is recommended to select the speed first with the variable, electronic speed regulator 6 and then switch on the appliance in order to work with the desired speed right from the beginning.
Recommended
Attachmentspeed range*
Dough bowl
| Whisk attachment | 7 | ... 15 |
| Mixing attachment | 5 | ... 15 |
| Kneading attachment | 1 | ... 7 |
Food processor bowl |
|
| |
| Blade | 7 | ... 15 |
- | Discs | 1 | ... 15 |
Liquidiser goblet |
|
| |
7 ... 15 * see sticker for housing
Pulse mode
The pulse mode is useful for the following applications:
•Carefully adding flour to doughs so as not to affect their creaminess.
•Adding whipped eggs or cream to more solid food.
•Chopping delicate and soft food, e.g. eggs, onions.
Turn the motor switch 4 to the «•• ••» position in order to start the automatic pulse mode. This causes short bursts of operation of identical length at the chosen speed. The function «•• ••» is switched off by switching the appliance off (motor switch 4 at «O»).
The manual pulse mode « » is operated by pressing the button 5 when the appliance is switched off (motor switch on «O»). Using the manual pulse mode, you can vary the length of the pulses. The appliance operates at the chosen speed as long as the button 5 is pres- sed down. When the button is released, the motor will stop.
Caution: max. 15 pulses per minute
Attaching and removing the dough bowl and the lid
Please clean all parts before using for the first time (see paragraph «Cleaning»).
For safety reasons, always carry or lift the appliance with both hands.
ÖPlace the bowl lonto the motor block 1so that the markings on the bowl match those on the motor block. Turn the bowl clockwise until it clicks.
Ü/á Push the attachment needed as far as possible onto the drive shaft in the bowl.
àPlace the lid 11 on the bowl so that the arrow on the lid matches the arrow on the bowl l. Then turn the lid clockwise until the nozzle (lug) on the lid enters the safety lock on the motor block and audibly snaps into place.
To remove, turn the lid
The filling tube j has to be inserted into the lid’s opening so that the higher rim is facing the inside. It allows more convenient adding of ingredients while processing.
Double safety lock: The motor can only be started if both the bowl l and the lid 11 are locked into place. The lid can only be removed from the bowl, if the motor is switched off.
When the appliance is switched off, turn the lid
11
Cleaning
Always switch off the motor first and then unplug the appliance before cleaning. Clean the motor block 1 with a damp cloth only.
Some types of food (e.g., carrots) can lead to discolouration; wipe off first with cooking oil before washing.
The kneading attachment 7 and the drive arm
8should only be cleaned manually. Do not immerse in water. All other parts can be washed in the dishwasher at a maximum temperature of 65 °C.
Parts which are difficult to reach, e.g., the indentation on the inside of the lid 11 should be well cleaned with the spatula 9 (e) and a brush if necessary.
Do not use sharp objects for cleaning.
Care and cleaning instructions for the stainless steel dough bowl
•Rinse in hot soapy water before first use.
•Rinse in hot soapy water as soon as possible after use, especially after processing very salty food.
•Stubborn food residues should be soaked and removed with a sponge (do not use a scouring pad) or brush.
•When cleaning in a dishwasher, remove the stainless steel bowl from the dishwasher as soon as the cleaning program is finished in order to prevent stains from remaining water drops. Be careful to avoid an overdose of cleaner and decalcifier.
•Carefully dry the bowl before storing it away.
Kneading
The kneading attachment 7 is specially designed for making yeast dough, pasta and pastries. It is not suitable for making cake dough. For cake dough, use the mixing attachment H.
Place all ingredients into the dough bowl l after the kneading attachment has been assembled.
Yeast dough (bread, cake)
Up to 1.5 kg flour plus ingredients:
Speed | 3 to 5 minutes |
First, place the flour and then all other ingredients – except milk – into the dough bowl, including raisins, candied peel and almonds.
10