Cuno 111405-1 E E Z E R C O M P a R T M E N T, Adjustable Wire Shelves, Freezer Elevator Shelf

F R E E Z E R C O M P A R T M E N T

ADJUSTABLE

WIRE SHELVES

TO REMOVE WIRE SHELVES:

•Completely unload the shelf or remove basket.

•Lift up the rear of the shelf slightly.

•Pull the shelf straight out.

TO LOCK THE SHELF INTO ANOTHER POSITION:

•Tilt up the front edge of the shelf.

•Lift up the rear of the shelf.

•Insert the hooks into the desired frame openings.

•Let the shelf settle into place.

Be sure the shelf is level and securely locked at the rear before reloading it with food.

FREEZER ELEVATOR™ SHELF

This shelf can be

adjusted up or down without being unloaded.

To adjust the height, pull out

the knob on the handle built into the shelf front. Turn the handle clockwise to raise the shelf and counterclockwise to lower the height of the shelf.

TO REMOVE SHELF:

•Completely unload the shelf.

•Slide the shelf out until it stops.

•Push up the tabs under the outside edges of the shelf behind the bracket and continue pulling the shelf out, clear of the frame.

TO REINSTALL SHELF:

•Align the shelf into the guides on the frame.

•Push the shelf all the way back. (It is not necessary to push up the tabs for rein- stallation).

In ordinary use, the Elevator™ shelf frame assembly does NOT require removal.

In the unlikely event that the assembly needs removal, it is important to follow the correct removal procedure. See page 7.

WIRE FREEZER

BASKETS

To load or retrieve items from a freezer basket, pull the drawer for- ward.

TO REMOVE:

•Pull out the drawer out until it stops.

•Tilt up the front of the basket.

•Lift it completely out.

TO REPLACE:

•Place basket on extended tracks.

•Place tabs on basket sides under tabs on track. Drawers should sit flat on track.

•Push drawer all the way in.

ICE DRAWER

(Non-dispenser Models)

The automatic icemaker keeps this drawer stocked with ice. To retrieve ice, pull open the drawer.

TO REMOVE:

•Pull out the drawer until it stops.

•Reach into the drawer compartment and move the wire lever arm on the ice- maker into the up (OFF) position.

•Lift the front of the drawer up.

•Pull the drawer completely out.

TO REINSTALL:

•Align the drawer sides onto the matching side rails.

•Reach into the drawer compartment and move the wire lever arm on the ice- maker into the down (ON) position.

•Push the drawer in.

10