Cuno 111405-1 manual I N T E N a N C E, Condenser, Light Bulb Replacement

M A I N T E N A N C E

CONDENSER

Cleaning of the condenser is recom- mended every 3-6 months.

TO CLEAN:

•Remove Machine Compartment cover (see page 4).

•Turn the power to the unit off using the Main Power switch.

NOTE:

Turning the power off on the elec- tronic control panel inside the refriger- ator stops cooling only in both com- partments. It DOES NOT turn off power to the unit.

•Use the soft brush vacuum

attachment to loosen dust

and lint on

the condenser fins. Vacuum to remove the soil.

•After cleaning, turn the Main Power switch back on.

•Replace the machine compartment cover.

LIGHT BULB

REPLACEMENT

UPPER FRESH FOOD AND FREEZER COMPARTMENTS

There are light bulbs at the top of each compartment.

WARNING: Always re- member to turn off (“O”) the power to the refrigerator at the main power switch and to wear gloves when replacing light bulbs.

TO ACCESS THE UPPER LIGHT BULB AREA IN EITHER COMPARTMENT:

• Push in on the finger-

tabs located behind the

electronic control panel at the top of the compartment.

•Lower the light shield.

•Replace the burned out bulb(s) with standard A15-40 watt appliance bulb(s). Available from your dealer (part number 31956).

•After replacing

the bulb(s), push the light shield up into its orig- inal position.

LOWER FRESH FOOD

COMPARTMENT

There is a T8-40 watt bulb located behind each ClimateZone™ drawer. Replace- ment bulbs are available from your dealer (MCS part number 61008236).

IMPORTANT:

•To avoid damage to the Climate- Zone™ drawers, power must be turned off at the Main Power switch (see page 3) before changing the bulb.

TO REPLACE THE BULB BEHIND THE UPPER CLIMATEZONE™ DRAWER:

•Turn the power off to the refrigerator at the Main Power switch in the upper machine compartment (see page 4).

•Unload and remove the upper ClimateZone™ drawer.

•Remove the ClimateZone™ Air Diverter located at the rear of the fresh food compartment.

•Lift up and remove the glass shelf.

Air Diverter

Strip

Shelf

•After the shelf is removed, 2 mounting

screws are visible behind the drawer. Using a 1⁄4" hex head screw driver, remove these screws.

•Slide the compartment assembly forward.

•Unscrew the bulb and replace with a new T8-40 watt bulb.

•Slide the assembly back into its original position. Align the screw holes, making sure air ducts are in alignment. Replace the two screws. Replace the shelf and the air diverter strip. Reinsert the drawer into the compartment.

•Turn the power to the refrigerator back on.

IMPORTANT:

•Do not remove the foam piece between the ClimateZone™ drawers.

19