GE Monogram ZISB42D Slide carton off top of cabinet, Shut off the main water supply, Washer

Step 1

Remove

Packaging

PRODUCT INSTALLATION

Installation

42" Built-In Refrigerator

CAUTION

Refrigerator is much heavier at the top than at the bottom – be careful when moving. When using a hand truck, handle from side only.

PRUDENCE

Le réfrigérateur est beaucoup plus lourd en haut qu'en bas. Il faut être prudent lors des déplacements. Si un diable est utilisé, il faut soulever le réfrigérateur sur le côté seulement.

• Remove outer carton.
– Carefully cut banding at the top and bottom.
• Slide out back corner posts (2).	7/16" Bolt
• Slide carton off top of cabinet.
NOTE: IT IS NOT NECESSARY TO LAY CABINET DOWN
IN ORDER TO REMOVE SKID!
• To remove skid, remove the four 7/16" bolts and their
brackets.

CAUTION

DO NOT ATTEMPT TO ROLL UNIT OFF SKID.

PRUDENCE

IL NE FAUT PAS ESSAYER DE FAIRE ROULER LE RÉFRIGÉRATEUR POUR L'ENLEVER DE LAY PALETTE.

•There are support blocks on the bottom of the cabinet and door. They must be removed before sliding unit off the skid or damage will occur.

•Carefully, tilt cabinet and slide blocks out from beneath cabinet, slide unit off skid.

•Remove toekick from fresh food compartment and set aside for later installation.

Step 2

Install

Water Line

•A cold water supply is required for automatic icemaker operation. The water pressure must be between 40 and 120 p.s.i.

•Route 1/4" OD copper tubing between house cold water line and the water connection location.

•Copper tubing should be long enough to extend to the front of the refrigerator. Allow enough to accommodate bend leading into the water valve.

Shut off the main water supply.

Turn on the nearest faucet long enough to clear the line of water.

•Install a shut-off valve between the icemaker water valve and cold water pipe in a basement or cabinet. The shut-off valve should be located where it will be

	Floor
Copper Tubing
Saddle Type	Washer	Inlet End

Shutoff Valve

easily accessible.

Packing Nut

Pipe Clamp

16

NOTE: It is best to install the valve into a vertical water pipe. If you install the valve into a horizontal water pipe, make the connection at the top or side, rather than at the bottom, to avoid drawing off any sediment from the water pipe.

•Drill a 1/4" hole in the water pipe.

•Fasten the shut-off valve to the pipe with pipe clamp.

•Tighten the clamp screws until the sealing washer begins to swell. Do not over tighten.

•Place a compression nut and ferrule (sleeve) onto the end of the tubing and connect it to the shut-off valve. Make sure the tubing is fully inserted into the valve and ferrule is tightened.

•Turn on the main water supply and flush debris from the line. Run about a quart of water through the tubing into a bucket. Shut off water supply at the shut-off valve.

Compression Nut

Outlet Valve

Ferrule (Sleeve)

NOTE: Saddle type shut-off valves are included in many water supply kits. Before purchasing, make sure a saddle type valve complies with your local plumbing codes.

NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber.