GE Monogram ZISW42D, ZIS42N, ZISB42D ZKHSS1 for 1/4 Panels, Tubular Stainless Steel Handles

ZKHSS1 for 1/4" Panels

Tubular Stainless Steel Handles

This kit provides for the installation of Stainless Steel custom handles on 1/4" thick decorator door panels. The door extru- sions allow these custom handles to be secured to the door structure, rather than to the custom panels. This kit contains all the necessary parts for dispenser and non-dispenser models.

Tools and materials required:

•#2 Phillips screwdriver

•Drill and 1/8", 9/32" bits

•Custom door panels

•Safety glasses

•Center punch

•Masking tape

•Hammer

•Pencil

•1/2" thick 12" x 12" min. piece of plywood to protect floor when drilling

•For stainless steel panels wear gloves to protect against sharp edges.

Parts List:

A. Fresh food door extrusion B. Freezer door extrusion

C. 2 Stainless tubular handles

D. 10 Spacer rings (for Stainless panels ONLY) (8 required, 2 extra)

E. 8 Handle standoffs

F. 10 Screws for mounting handle standoffs (8 required, 2 extra)

G. 10 Set screws (8 required, 2 extra) H. 3/32" Allen wrench for set screws

Note: It is best that 2 people install this kit.

A

B

C

D

E

F

G

H

ZKHSS1 INSTALLATION

Step 1:	• Open doors to 90°. Remove the screws from the full-
Remove	length handles of both doors.
Handles	• Retain screws, discard handles.
	• Locate the 2" x 2" adhesive foam pads packed with
	the refrigerator. Apply pads to the doors as shown.
	Corner pads should be as close to inside corners as
	possible.

Note: If a custom collar is to be used, order ZWCD1 Trim Kit for 42" and 42" wide models. Order ZWCD2 for 48" wide models.

38