GE Monogram ZISW42D Consulter « Mise à terre du réfrigérateur », Design Information, Trim Kits

Page 2

Before you begin - Read these instructions completely and carefully. IMPORTANT - Save these instructions for local inspector’s use.

IMPORTANT - OBSERVE ALL GOVERNING CODES AND ORDINANCES. Note to Installer - Be sure to leave these instructions with the Consumer.

Note to Consumer - Keep these instructions with your Use and Care Book for future reference.

WARNING This appliance must be properly grounded. See “Grounding the Refrigerator,” page 15.

ATTENTION Cet appareil doit être correctement mis à la terre.

Consulter « Mise à terre du réfrigérateur », page 15.

If you have a question concerning the installation of this product, call the GE Answer Center® Consumer Information Service at 800.626.2000, 24 hours a day,

7 days a week.

If you received a damaged refrigerator, you should immediately contact your dealer or builder.

Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered under the GE Appliance Warranty. See the Use & Care Guide for warranty information.

For Monogram local service in your area, 1-800-444-1845.

For Monogram service in Canada, 1-888-880-3030. For Monogram Parts and Accessories, call 1-800-626-2002.

WARNING

Use this appliance only for its intended purpose.

Immediately repair or replace electric service cords that have become frayed or damaged.

Unplug the refrigerator before cleaning or making repairs.

Repairs should be made by a qualified service technician.

ATTENTION

Il ne faut utiliser cet appareil que pour l’usage pour lequel il a été construit.

Il faut réparer ou remplacer immédiatement tout cordon d’alimentation électrique effiloché ou endommagé.

Débrancher le réfrigérateur avant le nettoyage ou toute intervention.

Les réparations doivent être faites par un technicien qualifié.

Contents

Design Information

 

 

Advance Planning for a Flush Installation

3

 

Cutout and Product Dimensions

3

 

Installation Between Base & Wall Cabinets

4

 

Installation At End-of-Run

4

 

Frameless Cabinets

4

 

Accessory Panel Kits

4

 

Advance Planning, Exterior Appearance Options

5

 

Appearance Examples, Trim Kit Descriptions

5

 

Custom Panel Dimensions

 

 

ZIS42N

6-9

 

ZISW36D, ZISB36D

10-13

 

Side Panel or Filler Options

14

 

Installation Instructions

15-20

 

Trim Kits

 

 

ZKH1 Trim Kit Installation Instructions

 

 

Custom Handles with 1/4" Thick Panels

21-25

 

ZG2 Trim Kit Installation Instructions

 

 

Grille Panel Frame Adjustment

26

 

ZKT42 Trim Kit Installation Instructions

 

 

3/4" Thick Custom Panels

27-32

 

ZKHT1 Trim kit Installation Instructions

 

 

Custom Handles with 3/4" Thick Panels

33-37

 

ZKHSS1 Trim Kit Installation Instructions

 

 

Tubular Stainless Steel Handles for 1/4" Panel Installation

38-41

 

ZKHTSS1 Trim Kit Installation Instructions

 

 

Tubular Stainless Steel Handles for 3/4" Panel Installation

42-45

 

ZWCD1 Trim Kit Installation Instructions

 

 

Custom Dispenser Collar

46-47

2

Image 2
Contents GE Monogram Built-In Refrigerators ModelsDesign Information Custom Panel DimensionsConsulter « Mise à terre du réfrigérateur », Trim KitsDesign Information True Flush InstallationTo accomplish an attractive installation, you must Built-In Refrigerator41-1/2 Built-In RefrigeratorsThick CabinetYou should Thick custom panels-Without trim kitsCustom Panel Dimensions Non-dispenserZIS42N non-dispenser Custom door and grille panels, using the standard full Using Trim Kit ZKT42 Thick panel with standard handleZKT42 trim kit provides for the installation of 3/4 67 15/16Freezer Panel MaxZISW42D white dispenser ZISB42D black dispenserCustom Door Panel Dimensions Using Standard Trim ZISW42D white dispenser ZISB42D black dispenserDispenser Brackets and install see detail a Length handle. Cut panels to size and installLower freezer panel to allow placement of support Grille Panel height can vary to fill installationSee detail B Standard Custom 67 15/16 Detail a and installDetail B Freezer Rout panels to specification below on Detail B24 3/4 For All Monogram Built-In Refrigerators23 9/16 TrimUse of Extension Cords InstallationUse of Adapter plug Floor Copper Tubing Slide carton off top of cabinetShut off the main water supply WasherStep Install Side Panels Side panels must be installed plumbFor Installations With a Reverse Osmosis System Only Rotate Clockwise To Remove Filter Bypass PlugStep Roll Refrigerator Into Opening To install 1/4 door panelsStep Install Door Panels Step Level RefrigeratorRefrigerator Door Spacer Block Open freezer door to access case trimBlock Top View Refrigerator Cabinet To insert decorative grille panel into the frame Installation height and must be adjustedTo raise or lower case trim to other installation heights Support for Custom Handles Parts ListZKH1 Trim Kit For 1/4 Panels Tor door panels. Handles not included. The doorOption 1 Installation Step Locate positionOption 1 Installation Step Assemble panel Extrusion Handle Extrusion Decorator Door Panel Handle Min 2 Max Door HandleRe-install dispenser trim, temporarily Step Locate Position HandleDispenser Option 2 Installation Step Custom handleAssembled Trim WithTo change grille panel size Grille Panel Frame AdjustmentZG2 Trim Kit Freezer Door Top trim Side trim Bottom trim Fresh Food Door ZKT42 Trim KitCustom Panels Models TrimDimension B Secure 3/4 panel to grille panel support Option 1 Installation Step Adjust Grille panel HeightStep Install1/16 Grille panel ZKT42-6-3/4 Dimension a Dimension BInstall panel support brackets Back Side Freezer Panels Hinge Upper LowerStep Install Panels Step Install HandlesFreezer door extrusion ZKHT1 Trim Kit For 3/4 PanelsFresh food door extrusion Back SideStep Temporarily Mount Door panels Step Locate position of handlesStep Mount assembled panels Option 1 Installation Assemble panel, extrusion HandleMin 2 Max Screw For dispenser Option 1 InstallationModel using BeforeAssembled Tools and materials required ZKHSS1 for 1/4 PanelsTubular Stainless Steel Handles See a for Stainless Steel panels Extrusion Decorator Door PanelStep Match Handle Extrusions to Handle See a Reinstall original screws into the door extrusionTape extrusions to panels to prevent movement For StainlessFor Stainless Panels Raised Panel on 1/4 Thick BackingZKHTSS1 for 3/4 Panels Tubulor Stainless Steel HandlesFreezer panels Step Install Standoffs onto Handles Step Install Assembled PanelsZKHTSS1 Collar trim ZWCD1 Trim KitCustom Dispenser Collar 17 11/16 67 7/8 15 1/4 67 15/16 15 1/16 15 5/16Select the door panel size for your application Monogram