Kenmore 665.1702, 665.1703 Cup shelves, Utensil basket on some models, To adjust the top rack

•Loadplasticitemssotheforceofthespraydoesnotmove themduringthecycle.

•Toavoidchipping,donotletstemwaretouchotheritems.

•Smallbowls,pans,andotherutensilscanbeplacedinthe

toprackLoadbowlsinthecentersectionforbeststability..

Utensil basket (on some models}

Use this extra capacity basket in the back of the top rack to hold spatulas, wooden spoons, and similar items.

Cup shelves

Fold down the extra shelf on the left-hand or right-hand side of the top rack to hold additional cups, stemware or long items such as utensils and spatulas.

NOTE: The features on your dishwasher may vary from those shown below.

Deluxe adjustable 2-position top rack (on some models)

You can raise or lower the top rack to fit tall items in either the top or bottom rack. Raise the top rack to accommodate items up to 9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or lower the top rack to accommodate items up to 11" (28 cm) in both the top and bottom racks. Adjusters are located on each side of the top rack.

::¸

To raise the top rack

Lift the rack on both sides until the rack is level.

NOTE: The top rack must be level.

To lower the top rack

Depress both tabs on rack adjusters, as shown above, and slide the rack back to its original position.

Standard adjustable 2-position top rack (on some models)

You can raise or lower the top rack to fit tall items in either the top or bottom rack. Raise the top rack to accommodate items up to 9" (22 cm) in the top rack and 13" (33 cm) in the bottom rack, or lower the top rack to accommodate items up to 11" (28 cm) in both the top and bottom racks. Two adjusters are located on each side of the top rack. Each adjuster has 2 preset positions. The high and low positions are marked on the adjuster.

To adjust the top rack

1.Hold the top rack with one hand near the adjuster.

_IOH

2.With the other hand, pull out the top of the adjusteE & Raise or lower the rack to one of the preset positions,

4.Release the adjuster.

5.Repeat the steps for the remaining adjusters. NOTE: The top rack must be level,

such as stock pots, roasters, and cookie sheets in the bottom

To remove the top rack

1.Pull the rack forward slightly to access clips.

2.While pressing the ridges in, push back on the clip until the outer side releases. Slide the clip to the inside of the track edge to remove the clip.

3.After removing both clips, pull rack out.

To replace the top rack

1.Place the rollers on each side of the rack into the rack tracks and push the rack back.

2.Align the open side of the clip with the inside edge of the rack track.

3.Push the ridges and slide the clip toward the outside rack edge until it locks into place.

4.Repeat on the other side.

5.Pull the rack out all of the way to ensure clips are fully seated.