LockOn
Use the Lock On to prevent unintended use of the dishwasher. You can also use the lock feature to prevent unintended cycle or option changes during a cycle.
When LOCK ON is lit, all buttons are disabled.
NOTE: The dishwasher door can be opened while the controls are locked. However, the lock must be turned off and the Start/ Resume button pressed to resume the cycle.
To turn on the Lock
Press and hold HEATED DRY for 4 seconds. LOCK ON glows.
If you press any pad while your dishwasher is locked, the light flashes 3 times.
To turn off the Lock
Press and hold HEATED DRY for 4 seconds. The light turns off.
Delay Hours
Select this option to run your dishwasher at a later time or during
delay. After adding items, firmly close the door until it latches and press START/RESUME, or the delay will not continue.
To delay the start
1.Press the delay button to choose the number of hours delayed.
2.Select a wash cycle and options.
3.Press START/RESUME.
The dishwasher starts the cycle in the selected number of hours.
NOTES:
•To cancel the delay and cycle, press CANCEL/DRAIN.
•To cancel the delay and start the cycle, press START/ RESUME.
Follow the progress of your dishwasher with the Cycle Status indicators.
OWASHING
O SENSING
O DRYING
OSANITIZED
O CLEAN
Sensing
Your dishwasher senses the soil level on the dishes. Soil level determines the length of some cycles, the amount of heat added to the wash or rinse, and the cycle needed for the load. SENSING glows during the soil sensing parts of the cycle. Wash action continues while sensing occurs.
Sanitized
If you select the Sani Rinse option, Sanitized glows when the Sani Rinse cycle is finished. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This
can happen if the cycle is interrupted or the incoming water temperature is too low. The light turns off when you press any button or close the door.
Clean
Clean glows when a cycle is finished. The light turns off when you press any button or close the door.
The active vent reduces the sounds from your dishwasher. The vent closes, after the cycle starts, to lock in sound. The active vent opens when wash action ends and vapor is vented into room. Between cycles, the vent stays open for airflow, reducing the buildup of odors.
NOTE: There is a slight noise when the cover closes or opens. This is normal.
IMPORTANT: The vapor is hot. Do not touch the vent during drying.
£."2" ,,'\ -,-,
The overfill protection float (in the front right corner of the dishwasher tub) keeps the dishwasher from overfilling. It must be in place for the dishwasher to operate.
Check under the float for objects that may keep the protector from moving up or down.
16