Woods Equipment S15CD, S22CD, S20CD, S27CD, S25CD manual Advertencia, Be Careful

Page 12
50530315-A

SAFETY & INSTRUCTIONAL DECALS

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

Replace Immediately If Damaged!

(Safety Decals continued from previous page)

11 - PN 50530707

12 - PN 50530728

WARNING

ADVERTENCIA

HIGH-PRESSURE FLUID HAZARD

To prevent serious injury or death:

1. Relieve pressure on system before repairing, adjusting, or disconnecting.

2. Wear proper hand and eye protection when searching for leaks. Use wood or cardboard instead of hands.

3. Keep all components in good repair.

PELIGRO DE FLUIDO BAJO

ALTA PRESION

Para evitar heridas graves o la muerte:

1. Alivie la presión del sistema antes de hacer repara ciones, ajustes o desconecciones.

2. Use protección apropiada en las manos y en los ojos, cuando revise para ver si hay fugas. Utilice una tabla o un cartón en vez de las manos.

3. Mantenga todos los componentes en buen estado.

14 - PN 50530315

16 - PN 33347

DANGER

￿￿￿￿

￿￿

15 - PN 18864

￿￿￿￿￿￿

ROTATING DRIVELINE

 

CONTACT CAN CAUSE DEATH

KEEP AWAY!

 

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

DO NOT OPERATE WITHOUT -

￿ All driveline guards, tractor and

 

equipment shields in place

 

￿ Drivelines securely attached at both ends

￿ Driveline guards that turn freely on

 

￿￿￿￿￿￿33347E

driveline

18864-C

 

 

 

BE CAREFUL!

Use a clean, damp cloth to clean safety decals.

Avoid spraying too close to decals when using a pressure washer; high-pressure water can enter through very small scratches or under edges of decals causing them to peel or come off.

Replacement safety decals can be ordered free from your Woods dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319-6637.

12 Safety

MAN0506 (Rev. 9/5/2008)

 

 

Image 12
Contents Flail Shredder Introduction Table of Contents LEA EL InstructivoSpecifications Balance Statement General InformationSafety Rules PreparationTraining Operation TransportationMaintenance Storage Safety & Instructional Decals Replace Immediately If DamagedPeligro Advertencia Be CarefulOperator Record Operator SIGN-OFF RecordOperation Principal ComponentsBREAK-IN of the Flail Shredder After operating for 1/2 hourHorsepower Tractor WeightPRE-OPERATION Check List Choosing the Correct TractorPTO Driveline Length Attaching Shredder to Tractor With Quick Hitch AttachmentCut only the male end. Never cut the female end Without Quick Hitch Attachment Pull-Type ModelAttach PTO Driveline Attach Hydraulics Center Cutter OptionRaise Stands Removing Shredder from TractorPreparing for Operation Flail HeightSET Operating Height Point Hitch ModelsPull-Type Models Point & 2-Point Hitch ModelsSetting Flail Height Setting Outer Trailing Wheels Casters & StrutsStarting the Tractor Stopping the TractorCleaning Hazard AreaGround Speed TurningRubber Flaps Additional Rear WheelsBED Cones Service & Maintenance LubricantsGreasing Lubrication ScheduleLubrication Points Daily or every 8 hours of operation Every 25 hours of operationEvery 40 hours of operation AnnuallyLubrication Service Record Hours Serviced by Gearbox OIL LeakageHours or daily HoursGearbox leakage & Troubleshooting Changing Gearbox OILRatchet Height Adjustment Wheel SpacingReplacing Flail Knives Replacing Rubber Shield Flaps Servicing Rotors Flail TubesRemoving Components Replacing ComponentsReplacing Stub Shaft Servicing Weasler Modular Friction ClutchBreaking In the Clutch Run Removing the DrivelineRebuilding Friction Pack Rebuilding Overrunning ClutchMounting Clutch to Shredder Service & Maintenance Troubleshooting Problem Cause SolutionWorksheet for Contour Flail Patterns 24’ Assembly Wheel AssemblyDealer SET-UP Instructions For Some Models Shipped on EndPULL-TYPE Hitch Installation ALL UnitsPull-type units only Manual Storage Tube Installation Optional Equipment Rubber Belting InstallationRubber Flap Installation Safety Light KIT InstallationInstall Center Deflector Safety Light Kit Diagram Non-End TowCenter CUT KIT Installation Block ShreddedAssemble Motor and Blade Install Motor Housing Assembly HosesInstall Hose Clamps Install DecalsConnect Hoses to Tractor Remove Deflector KitDealer Check Lists PRE-DELIVERY Check ListDelivery Check List Dealer Check Lists Parts Index Flail Shredder Center Drive Flail Shredder Frame Assembly Center Drive Flail Shredder Frame Assembly Parts List Part QTY DescriptionFlail Tube Assembly Left RightTing BED Cone Assembly Optional Parts Dual Safety Light KIT Optional Weasler 24K Torqmaster Clutch Assembly Weasler Automatic Clutch OptionalWeasler 30K 3-POINT PTO Shaft with Automatic Clutch Optional 1019820 Center Drive Gearbox Rubber Belting Advertencia Center Cutter KIT OptionalCenter Cutter KIT Parts List Center Deflector OptionalRubber Flap Bolt Torque Chart SAE Series Torque ChartMetric Series Torque Chart Bolt Size Chart AbbreviationsAssembly IndexWarranty Rev /3/2011 Woods Equipment Company South Illinois Route Post Office Box Oregon, Illinois