Black & Decker CM2040 Securing the Motor Cable Figure J, Bagging, Mulching, Side discharge

Page 10

NOTE: Make sure the cord is located on the front of both handles. If it is not it may result in the cord tangling and the inability to easily store the mower (Figure I).

From the outside

 

I

 

of the upper

 

handle (3), slide

 

the lever bolt

 

through the holes.

 

Slide the washer

 

 

over the bolt of the

 

 

lever and loosely

 

 

assemble the

 

 

entire assembly

 

with the nut.

 

Rotate the upper

 

 

handle into its

 

operating position.

 

Close the lever. If it is too tight or too

 

loose, open the lever and the nut to

 

adjust the clamping. Check the levers

 

by closing them. They should be tight

 

enough so the handles are held firmly,

 

but loose enough so the levers can be

 

fully closed. Adjust by opening the lever

 

and turning the nut until the handles are

 

secured.

 

SECURING THE MOTOR CABLE (FIGURE J)

CAUTION: Attach cable so that it does not become stretched or pinched in the joints of the handles during use or folding. This can cause damage to the cord.

The motor cable (22) has to be fixed to the handles using the cable restraints (23) that are already attached to the handle. To clip the cable to the handle:

• Place the handles in operating position, see “Attaching Lower Handle” section.

• Run the cable up the front of the lower and upper handles.

• Pull back the cable restraint.

• Slide the motor cable under the clip and ensure it is fully held in place by the restraint.

J

23

22

Bagging

• Ensure the side discharge attachment (27) (Figure M) and the mulching insert

(26) (Figure L) are removed from the mower before bagging.

• Lift the rear door cover (9) and place the grass collection bag (8) onto the mower so the bag hooks (24) rest on the lugs (25) as shown in Figure K.

Then lower the rear door cover.

K 8

24

25

9

Mulching

• Ensure the side discharge attachment (27) and the collection bag (8) are not attached.

• Lift the rear door cover (9) and slide the mulching insert (26) fully into the mower as shown in Figure L.

• Ensure the rear door cover fully closes before turning mower on.

L

26

Side discharge

• Ensure the collection bag (8) is removed.

• Lift the rear flap (9) and slide the mulching insert (26) fully into the mower as shown in Figure L.

• Lift the side flap (28) and hook side discharge attachment (27) onto the mower as shown in Figure M.

• Release the side flap and ensure the attachment holds in place before turning mower on as shown in the insert of Figure M.

10

Image 10
Contents 40v Max* Lithium Cordless Mower General Operation Rotating blades can causeTo reduce risk of injury Do not operate mower barefooted orSlope Operation General ServiceChildren Safety Warnings and Instructions for ALL Tools Use identical replacement blades only Read all Instructions When the charger detects a Bad batteryHot/Cold pack delay Storage RecommendationsPage Battery Storage AssemblyTo remove battery pack  Attaching Lower HandleMulching Securing the Motor Cable Figure JBagging Side dischargeOperation Adjusting Handle Height Figure NSafety KEY BladeMower Overload Housing as shown in Figure P. The mower is now operationalTo turn the mower off, just release the bail handle StorageMower shold be compacted down as shown in Figure U Removing and Installing BladeMowing Tips Carrying the mowerWhen Sharpening the Blade Blade SharpeningBlade Balancing Figure Z1 CleaningMaintenance LubricationMower doesn’t run when bail handle is activated Black+Decker Authorized service centerService Information Mode D’EMPLOI Réduction des risques et des blessures En cours de fonctionnementLes objets percutés par la lame de la tondeuse peuvent Utilisation GénéraleRévision Générale ’utiliser que les accessoires approuvés par Black+DeckerEnfants Ne jamais laisser une tondeuse en marche sans surveillanceConserver ces mesures Bien entretenir la tondeuse à gazon Supplémentaires Pour TondeusesUtiliser seulement des pièces de rechange identiques Avertissement Avant l’utilisationDirectives DE Sécurité Importantes Pour LES BLOCS-PILES Procédure de charge Recommandations en matière de rangementFonctions de diagnostic du chargeur Pile en mauvais étatVérification de l’état de charge durant l’utilisation Insertion ET Retrait DU BLOC-PILESRetrait DU BLOC-PILES Pose DU BLOC-PILESFixation DE LA Poignée Inférieure AssemblageFixation DE LA Poignée Supérieure Figure H Ensachage FonctionnementFixation DU Câble DU Moteur Figure J DéchiquetageRéglage DE LA Hauteur DE LA Poignée Figure N CLÉ DE SûretéRéglage DE LA Hauteur DE LA Tondeuse Figure O Rangement DE LA Tondeuse EdgeMaxPour arrêter la tondeuse, relâcher simplement l’anse Transport DE LA Tondeuse Retrait ET Installation DE LA LameRégler la tondeuse à la hauteur Lors DE L’AFFÛTAGE DE LA Lame Affûtage DE LA Lame Dans UN Étau Figure ZNettoyage Équilibrage DE LA Lame Figure Z1Lubrication Prévention DE LA CorrosionInformation sur les réparations Le sceau SrprcmcSolution Guide DE DépannageManual De Instrucciones Para reducir el riesgo de lesiones Comprender el manual de instruccionesOperación General Nunca deje funcionando una poda- dora sin supervisión NiñosMantenimiento General Nunca se estire demasiado mientrasOs. Espere a que la podadora se enfríe antes de guardarla Compuestos en fertilizantes Peligro Advertencias Adicionales Para PodadorasUtilice únicamente hojas de repuesto idénticas Arsénico y cromo de madera con tratamiento químicoAdvertencia Descripción DE LAS FuncionesCorriente alterna Lea el manual de Corriente directa Lea todas las instrucciones Retraso por paquete caliente/frío Recomendaciones con respecto al almacenamientoProcedimiento de carga Cuando el cargador detecta queVerificación del estado de carga durante el uso Indicador DEL Estado DE LA Carga Figura aPara Instalar EL Paquete DE Baterías Almacenamiento DE Batería Para Extraer EL Paquete DE BATERÍAS Instalación DEL Mango Inferior Rote el mango superior a su posición de funcionamiento Instalación DEL Mango Superior Figura HFijación DEL Cable DEL Motor Figura J Recolección EN BolsaAjuste DE LA Altura DE LA Cortadora DE Césped Figura O FuncionamientoAjuste DE LA Altura DEL Mango Figura N Formación DE MantilloLlave DE Seguridad Sobrecarga DE LA PodadoraEdgeMax fig. R Almacenamiento DE LA Cortadora DE CéspedExtracción E Instalación DE LA Hoja Para Afilar LA Hoja EN UNA Prensa Figura Z AL Afilar LA HojaLimpieza Simetría DE LA Hoja Figura ZLubricación Prevención DE LA CorrosiónPage Guía DE Solución DE Problemas SoluciónAños DE Garantia Telephone · No. TeléfonoEsta Garantia no Aplica Cuando Av. Universidad No Av. Colón 2915 OteTel 998 884 72 Bolivia No