Black & Decker CM2040 instruction manual Blade Sharpening, When Sharpening the Blade

Page 14

reinstalled correctly, as described below. Improper assembly of the blade or other parts of the blade system may cause serious injury.

1.WARNING: release bail handle to turn mower off,

WAIT FOR THE BLADE TO STOP, AND REMOVE SAFETY KEY and battery pack.

2.Cut a piece of 2x4 wood (31) (about 2 feet long) (610 mm) to keep blade from turning while removing bolt (32).

3.Wear gloves and proper eye protection. Turn the mower on its side. Be careful of sharp edges of blade. Position wood and unscrew bolt with1/2” wrench (33) as shown in Figure W.

W

33

3132

4.Remove bolt and washer (34). Pull off blade (35) as shown in Figure X. The fan (36) should not be removed.

Examine all pieces for damage and replace if necessary.

X 34 36

32

35

5.The blade can only be attached to the fan in one direction. To reassemble, line up the D-shaped hole of the blade with the D-shaped post of the fan, ensuring the writing on the blade faces out away from the mower.

6.To tighten firmly, position the piece of wood as shown in Figure Y to keep the blade from turning. Slide the bolt through the washer and screw bolt into place. Tighten with the wrench.

Y

BLADE SHARPENING

KEEP BLADE SHARP FOR BEST MOWER PERFORMANCE. A DULL BLADE DOES NOT CUT GRASS CLEANLY.

USE PROPER EYE PROTECTION WHILE REMOVING, SHARPENING, AND INSTALLING BLADE. ENSURE THAT SAFETY KEY and battery pack IS REMOVED.

Sharpening the blade twice during a mowing season is usually sufficient under normal circumstances. Sand causes the blade to dull quickly. If your lawn has sandy soil, more frequent sharpening may be required.

REPLACE BENT OR DAMAGED BLADE IMMEDIATELY.

WHEN SHARPENING THE BLADE:

1. Make sure blade remains balanced.

2. Sharpen blade at the original cutting angle.

3. Sharpen cutting edges on both ends of blade, removing equal amounts of material from both ends.

TO SHARPEN BLADE IN A VISE: (Figure Z)

1. Be sure the bail handle is released, the blade has stopped and safety key and battery pack removed before removing the blade.

2. Remove blade from mower. See instructions for removing and installing blade.

3. Secure blade (35) in a vise (38).

4. Wear proper eye protection and gloves and be careful not to cut yourself.

5. Carefully file the cutting edges of the blade with a fine tooth file (39) or sharpening stone, maintaining the angle of the original cutting edge.

6. Check balance of blade. See instructions for blade balancing.

7. Replace blade on mower and tighten securely.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents 40v Max* Lithium Cordless Mower General Operation Rotating blades can causeTo reduce risk of injury Do not operate mower barefooted orChildren General ServiceSlope Operation Safety Warnings and Instructions for ALL Tools Use identical replacement blades only Read all Instructions When the charger detects a Bad batteryHot/Cold pack delay Storage RecommendationsPage Battery Storage AssemblyTo remove battery pack  Attaching Lower HandleMulching Securing the Motor Cable Figure JBagging Side dischargeOperation Adjusting Handle Height Figure NSafety KEY BladeMower Overload Housing as shown in Figure P. The mower is now operationalTo turn the mower off, just release the bail handle StorageMower shold be compacted down as shown in Figure U Removing and Installing BladeMowing Tips Carrying the mowerWhen Sharpening the Blade Blade SharpeningBlade Balancing Figure Z1 CleaningMaintenance LubricationMower doesn’t run when bail handle is activated Black+Decker Authorized service centerService Information Mode D’EMPLOI Réduction des risques et des blessures En cours de fonctionnementLes objets percutés par la lame de la tondeuse peuvent Utilisation GénéraleRévision Générale ’utiliser que les accessoires approuvés par Black+DeckerEnfants Ne jamais laisser une tondeuse en marche sans surveillanceConserver ces mesures Utiliser seulement des pièces de rechange identiques Supplémentaires Pour TondeusesBien entretenir la tondeuse à gazon Avertissement Avant l’utilisationDirectives DE Sécurité Importantes Pour LES BLOCS-PILES Procédure de charge Recommandations en matière de rangementFonctions de diagnostic du chargeur Pile en mauvais étatVérification de l’état de charge durant l’utilisation Insertion ET Retrait DU BLOC-PILESRetrait DU BLOC-PILES Pose DU BLOC-PILESFixation DE LA Poignée Supérieure Figure H AssemblageFixation DE LA Poignée Inférieure Ensachage FonctionnementFixation DU Câble DU Moteur Figure J DéchiquetageRéglage DE LA Hauteur DE LA Tondeuse Figure O CLÉ DE SûretéRéglage DE LA Hauteur DE LA Poignée Figure N Pour arrêter la tondeuse, relâcher simplement l’anse EdgeMaxRangement DE LA Tondeuse Régler la tondeuse à la hauteur Retrait ET Installation DE LA LameTransport DE LA Tondeuse Lors DE L’AFFÛTAGE DE LA Lame Affûtage DE LA Lame Dans UN Étau Figure ZNettoyage Équilibrage DE LA Lame Figure Z1Lubrication Prévention DE LA CorrosionInformation sur les réparations Le sceau SrprcmcSolution Guide DE DépannageManual De Instrucciones Operación General Comprender el manual de instruccionesPara reducir el riesgo de lesiones Nunca deje funcionando una poda- dora sin supervisión NiñosMantenimiento General Nunca se estire demasiado mientrasOs. Espere a que la podadora se enfríe antes de guardarla Compuestos en fertilizantes Peligro Advertencias Adicionales Para PodadorasUtilice únicamente hojas de repuesto idénticas Arsénico y cromo de madera con tratamiento químicoCorriente alterna Lea el manual de Corriente directa Descripción DE LAS FuncionesAdvertencia Lea todas las instrucciones Retraso por paquete caliente/frío Recomendaciones con respecto al almacenamientoProcedimiento de carga Cuando el cargador detecta quePara Instalar EL Paquete DE Baterías Indicador DEL Estado DE LA Carga Figura aVerificación del estado de carga durante el uso Instalación DEL Mango Inferior Para Extraer EL Paquete DE BATERÍAS Almacenamiento DE Batería Rote el mango superior a su posición de funcionamiento Instalación DEL Mango Superior Figura HFijación DEL Cable DEL Motor Figura J Recolección EN BolsaAjuste DE LA Altura DE LA Cortadora DE Césped Figura O FuncionamientoAjuste DE LA Altura DEL Mango Figura N Formación DE MantilloLlave DE Seguridad Sobrecarga DE LA PodadoraEdgeMax fig. R Almacenamiento DE LA Cortadora DE CéspedExtracción E Instalación DE LA Hoja Para Afilar LA Hoja EN UNA Prensa Figura Z AL Afilar LA HojaLimpieza Simetría DE LA Hoja Figura ZLubricación Prevención DE LA CorrosiónPage Guía DE Solución DE Problemas SoluciónEsta Garantia no Aplica Cuando Telephone · No. TeléfonoAños DE Garantia Av. Universidad No Av. Colón 2915 OteTel 998 884 72 Bolivia No
Top Page Image Contents