Manuals
/
Brands
/
Computer Equipment
/
Switch
/
Intel
/
Computer Equipment
/
Switch
Intel
410 manual
Please, tick the box below to download manual:
Contents
Main
Page
Contents
2 Host Adapter Installation
3 Installing and Using the RAID Manager for Windows NT
4 Completing your Configuration Setup under Windows NT
Revision Record
Page
About This Guide
Appendix A: Configuration Record
Appendix B: Accessing the Command Line Interpreter (CLI)
Associated Documents
Conventions
Getting Started
Installation Checklist
Pre-installation Steps:
Perform a System Backup
Verify User-Supplied Hardware and Software (System Requirements)
Inventory the StorageWorks RAID Array 410 Subsystem Platform Kit Components
Page
Page
1.2 Unpacking the RAID Array 410 (SWXRA-Yx)
1.3 Removing the RAID Array 410 from the Pallet
Page
1.4 Placing the RAID Array 410 Enclosure
1.5 Installing the SWXRC-04 Controller and Write-Back Cache Module
1.6 Installing the PC (Program) Card in the Controller
1.6.1 PC (Program) Card Handling Precautions
1.6.2 Installing PC (Program) Card in Controller
1.7 Connecting the Controller to Computer
1.8 Installing Additional Disk SBBs in the StorageWorks Enclosure
1.9 Charging the RAID Array Controller Write-back Cache Batteries
Page
Page
Page
Host Adapter Installation Intel-based System
2.1 Install the Host Adapter
2.1.1 Preparing to Install the Host Adapter
2.1.2 Installing the Host Adapter
2.2 Installing the Subsystem
Page
2.3 Configuration Utilities
2.4 Loading the Adapter Driver for Use with Windows NT
2.4.1 Windows NT Not Installed on System
2.4.2 Windows NT Previously Installed
2.5 Installing the RAID 300, 400 Series WNT Device Driver (HSZDISK.SYS Driver)
2.6 Verifying the System Recognizes the Host Adapter
Congratulations!
Page
Installing and Using the RAID Manager for Windows NT
3.1 RAID Manager for Windows NT
3.2 Overview: Installing and Using the RAID Manager for Windows NT
3.3 Installing the RAID Manager Software
3.4 Setting Controller Communications
3.5 Setting the Controller Configuration
Page
3.6 Creating an Initial Configuration
3.6.1 Displaying Physical/Logical View of System
Page
3.6.2 Practice Example: Creating a Single Disk
3.6.3 Practice Example: Creating a Stripeset
3.6.4 Practice Example: Creating a Mirrorset
3.6.5 Practice Example: Adding a Spare Disk
3.6.6 Practice Example: Deleting Storagesets
Congratulations!
3.7 Saving the RAID Configuration
Page
Page
Completing your Configuration Setup under Windows NT
4.1 Completing Configurations under Windows NT
4.1.1 Verifying that hszdisk.sys Loaded
4.1.2 Completing a New RAID Array Configuration
Understanding the Disk Administrator Display
Page
Page
Page
4.1.3 Changes to RAID Array Configuration
Page
Page
Page
Page
Page
B
Accessing the Command Line Interpreter (CLI)
B.1 What is the CLI?
B.2 Accessing the CLI
Page
Readers Comments