Intel 1.2Unpacking the RAID Array 410 SWXRA-Yx, 1.3Removing the RAID Array 410 from the Pallet

Getting Started - RAID Array 410 for Windows NT – Intel

1.2Unpacking the RAID Array 410 (SWXRA-Yx)

The RAID Array 410 is packed in a corrugated carton attached to a wooden shipping pallet, as shown in Figure 1–2A. Unpack the unit as follows:

NOTE

Before unpacking the equipment, inspect the shipping carton for signs of external damage. Report any damage to the local carrier and to your sales representative.

1.Remove the shipping straps (Figure 1–2A).

2.Remove the top cover (Figure 1–2B).

3.Remove the ramp from the top of the shipping carton (Figure 1–2B) and set it aside for subsequent use in moving the RAID Array 410 off the pallet.

4.Remove the two foam cushions from the top of the RAID Array 410 container (Figure 1–2B).

5.Remove the sealed cardboard box packed beside the subsystem unit. It contains a cable and documentation.

6.Remove the cardboard carton surrounding the RAID Array 410 (Figure 1–2B).

7.Remove the plastic barrier bag (Figure 1–2C).

8.Once the RAID Array 410 is exposed (Figure 1–2D), examine the equipment for any ap- parent damage. Report any such problems immediately to your sales representative.

1.3Removing the RAID Array 410 from the Pallet

Use the following procedure to remove the RAID Array 410 from the shipping pallet:

WARNING

Serious personnel injury can result if correct safety precautions are not taken during the removal procedure.

We recommend that three people perform the task of unloading the RAID Array 410 Array from its shipping pallet. Failure to use sufficient personnel can result in personnel injury and equipment damage.

CAUTION

Do not drop the RAID Array 410 array from a height of more than two inches, as serious structural damage to the enclosure can re- sult.

1.Attach the ramp to the shipping pallet by fitting the lip of the ramp into the groove on the pallet, as shown in Figure 1–3.

2.Lift the lock lever on each front caster to its up position so that the RAID Array 410 en- closure can be moved.

1–2 EK–SMRAC–IG. C01