Getting Started – RAID Array 410 for Windows NT –Intel

3.Set the communications parameters to:

9600 baud

8 bits

1 stop bit

No parity

4.From your communication program, issue a connect command to establish a connection with the controller, and then press the Enter key. You should see the CLI prompt, which looks similar to

SWXRC>

From this prompt, you may issue your CLI commands. For further information regarding CLI commands, reports, etc., refer to the SWXRC RAID Array Controller User’s Guide (EK- SMCS1-UG).

B–2

EK–SMRAC-IG. C01

Page 58
Image 58
Intel 410 manual Set the communications parameters to