Intel manual 1.4Placing the RAID Array 410 Enclosure

Getting Started - RAID Array 410 for Windows NT – Intel

3.Grasping the sheet metal base assembly, carefully lift the rear of the RAID Array 410 enclosure over the “hump” in the center of the pallet and then roll the RAID Array 410

enclosure off the pallet and down the ramp to the floor. If any further lifting of the RAID Array 410 is required, grasp the sheet metal base assembly on the side and lift it care- fully.

4. Retain the shipping container and all packing materials.

1.4Placing the RAID Array 410 Enclosure

Use the following procedure to move the enclosure to its designated site:

WARNING

To prevent damage to the RAID Array and injury to personnel, make sure to provide a clear path for the casters.

1.Roll the enclosure to the desired location.

2.If required, engage the lock on each front caster to prevent the enclosure from moving.

1.5Installing the SWXRC-04 Controller and Write-Back Cache Module

Unlock the enclosure, if necessary, using the keys provided. If the SWXRC-04 RAID Array controller and the write-back cache module have not been installed in your StorageWorks enclosure, you should install them at this time. Do so by referring to Chapter 3, Installing the Storage Subsystem, in the SWXRC RAID Array Controller User’s Guide (EK-SMCS1-UG), included with the subsystem.

If your system is to be configured for dual-redundant controller operation, install the second controller and associated components at this time . Refer to Chapter 3, Installing the Storage Subsystem, in the SWXRC RAID Array Controller User’s Guide (EK-SMCS1-UG).

NOTE

Review the information contained in any Release Notes included with the system. The Release Notes contain version-specific in- formation, including controller configuration notes. Retain the Re- lease Notes for future reference.

1.6Installing the PC (Program) Card in the Controller

CAUTIONS

Follow these precautions and PC (program) card handling guide- lines when installing or replacing the card. Install the (PC) program card in the SWXRC-04 RAID controller after the controller has been installed in a properly grounded SWXSC-AA cabinet. Other- wise, damage to the card may result.

The PC (program) card electrostatic discharge (ESD) shield must remain installed over the card during controller operation to protect it from electrostatic discharge that may cause the contents of the card to be damaged.

1–4 EK–SMRAC–IG. C01