3Com 7600 manual Following is a sample ATM address display, 2ATM Address Display

7-4CHAPTER 7: MANAGING ATM RESOURCES

Table 7-4ATM Address Fields

Field	Description
Source	The source of the ATM addresses:
	Q Automatically assigned by ILMI
	Q Manually assigned and saved in flash memory
	In order to use ILMI automatically, this value should not
	be assigned manually.
State (in ILMI)	State of the ATM address within ILMI. If no address has
	been manually assigned, ILMI is automatically used. In
	this case, it should normally be in the Registered state.

Example

Enter: [4] [2] [1]

The following is a sample ATM address display:

--------------------------------------------------------------------

Bridge		ATM Address	SourceState
				(in ILMI)
+------	+	----------------------------------------	+	------+-----------	+
0	4700000009000000000000000000c0da18050c00 ILMI *REGISTERD*

--------------------------------------------------------------------

Figure 7-2ATM Address Display

Update Bridge ATM Enter the bridge number and the ATM address (or “!” to invalidate the

AddressATM address) to update the local ATM address. An ATM address entered by this command will override the ILMI address registration for the specified bridge. When you change the ATM address manually it must be coordinated with the ATM switch. Use the invalidate command (“!”) to reset the ATM address, so as to restore the automatic ILMI address registration for the specified bridge.