3Com 9100 manual Important Safety, Information

138APPENDIX A: SAFETY INFORMATION

Important Safety	■	Installation and removal of the unit must be carried out by qualified
Information		personnel only.
	■ If installing the Switch 9100 in a stack with SuperStack II units that are
		narrower than the 9100, the Switch 9100 unit must be installed
		below the narrower units.
	■ The unit must be earthed (grounded).
	■ Connect the unit to an earthed power supply to ensure compliance
		with safety standards.
	■	Power Cord Set:
		This must be approved for the country where it is used:

U.S.A. and Canada

United Kingdom only

Europe only:

Denmark

Switzerland

■The cord set must be UL-approved and CSA certified.

■The minimum specification for the flexible cord is: No. 18 AWG

Type SV or SJ 3-conductor

■The cord set must have a rated current capacity of at least 10A.

■The attachment plug must be an earth-grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A, 250V) configuration.

■The supply plug must comply with BS1363 (3-pin 13 amp) and be fitted with a 5A fuse which complies with BS1362.

■The mains cord must be <HAR> or <BASEC> marked and be of type H03VVF3GO.75 (minimum).

■The supply plug must comply with CEE 7/7 (“SCHUKO”).

■The mains cord must be <HAR> or <BASEC> marked and be of type H03VVF3GO.75 (minimum).

■The supply plug must comply with section 107-2-D1, standard DK2-1a or DK2-5a.

■The supply plug must comply with SEV/ASE 1011.

■The appliance coupler (the connector to the unit and not the wall plug) must have a configuration for mating with an EN60320/IEC320 appliance inlet.

■Disconnect both AC power leads before servicing.

■The socket outlet must be near to the unit and easily accessible. You can only remove power from the unit by disconnecting the power cord from the outlet.