56CHAPTER 3: ACCESSING THE SWITCH

Flow Control Flow control is supported on Gigabit Ethernet ports. It is enabled or disabled as part of autonegotiation. If autonegotiation is set to off, flow control is disabled. When autonegotiation is turned on, flow control is enabled.

Switch 9100 Port Table 16 describes the Switch 9100 port commands.

Commands

Table 16 Switch 9100 Port Commands

Command

Description

 

 

enable learning ports <portlist>

Enables MAC address learning on one or more

 

ports. The default setting is enabled.

enable ports <portlist>

Enables a port.

enable sharing <master_port>

Defines a load-sharing group of ports. The ports

grouping <portlist>

specified in <portlist> are grouped to the master

 

port.

config ports <portlist> auto on

Enables autonegotiation for the particular port type;

 

802.3u for 100/1000 Mbps ports or 802.3z for

 

Gigabit Ethernet ports.

config ports <portlist> auto off {speed [100 1000]} duplex [half full]

config ports <portlist> display-string <string>

Changes the configuration of a group of ports. Specify the following:

auto off — The port will not autonegotiate the settings.

speed — The speed of the port (for 100/1000 Mbps ports only).

duplex — The duplex setting (half- or full-duplex).

Configures a user-defined string for a port. The string is displayed in certain show commands (for example, show port all info). The string can be up to 16 characters.

config ports <portlist> qosprofile

Configures one or more ports to use a particular

<qosname>

QoS profile.

unconfig ports <portlist>

Clears the user-defined display string from a port.

display-string <string>

 

(continued)

Page 56
Image 56
3Com 9100 Enable learning ports portlist, Enable ports portlist, Enable sharing masterport, Grouping portlist, Qosname