3Com 9100 manual Using Snmp, Accessing Switch, Agents, Supported MIBs

Using SNMP 51

	The default home page of the switch can be accessed using the following
	command:
	http://<ipaddress>
	When you access the home page of the switch, you are presented with
	the Logon screen.
	For more information on using the Web Interface, refer to Chapter 9.
Disabling Web Access	By default, Web access is enabled on the switch. To disable it, enter the
	following command:
	disable web
	To re-enable Web access, enter the following command:
	enable web {access-profile <access_profile> none} {port
	<tcp_port_number>}
	Reboot the switch for these changes to take effect.
	For more information on rebooting the switch, refer to Chapter 10.
Using SNMP	Any Network Manager running the Simple Network Management
	Protocol (SNMP) can manage the switch, provided the Management
	Information Base (MIB) is installed correctly on the management station.
	Each Network Manager provides its own user interface to the
	management facilities.
	The following sections describe how to get started if you want to use an
	SNMP manager. It assumes you are already familiar with SNMP
	management.
Accessing Switch	To have access to the SNMP agent residing in the switch, at least one
Agents	VLAN must have an IP address assigned to it.
	For more information on assigning IP addresses, refer to Table 9.
Supported MIBs	Any Network Manager running SNMP can manage the switch, provided
	the MIB is installed correctly on the management station. In addition to
	private MIBs, the switch supports the standard MIBs listed in Appendix B.