3Com 9100 manual IP Host, Commands, Using the Web, Interface, On the switch

50CHAPTER 3: ACCESSING THE SWITCH

IP Host	Table 12 describes the commands that are used to configure IP settings
Configuration	on the switch.
Commands
Table 12 IP Host Configuration Commands
Command		Description
config iparp add <ipaddress>		Adds a permanent entry to the Address
<mac_address>		Resolution Protocol (ARP) table. Specify the IP
		address and MAC address of the entry.
config iparp delete <ipaddress>		Deletes an entry from the ARP table. Specify
		the IP address of the entry.
config iparp timeout <minutes>		Configures the IP ARP timeout period. The
		default setting is 20 minutes. A setting of 0
		disables ARP aging.
clear iparp {<ipaddress> vlan <name>}		Removes dynamic entries in the IP ARP table.
		Permanent IP ARP entries are not affected.
config iproute add default <gateway>		Adds a default gateway to the routing table.
{<metric>}		A default gateway must be located on a
		configured IP interface. If no metric is
		specified, the default metric of one is used.
config iproute delete default <gateway>		Deletes a default gateway from the routing
		table.
show iparp {<ipaddress> vlan <name>		Displays the IP ARP table. You can filter the
permanent}		display by IP address, VLAN, or permanent
		entries.
show iproute {vlan <name> <ipaddress>		Displays the contents of the IP routing table.
<mask>}
Using the Web	The Web Interface is device-management software running in the switch
Interface	that enables you to access the switch over a TCP/IP network using a
	standard Web browser. Any properly configured standard Web browser

that supports frames (such as Netscape Navigator 3.0 or Microsoft Internet Explorer 3.0) can manage the switch over a TCP/IP network.

For more information on assigning an IP address, refer to the section, “Configuring Switch IP Parameters,” on page 46.