3Com S200 manual PAD Prompt Table Record Parameters, Entry Number, PAD Prompt Text, Introduction

PAD Prompt Table Record

PAD Prompt Table Record Parameters

Introduction	This section describes the PAD Prompt Table parameters.
Parameters
	From the PAD Prompt Table Record, you can configure these parameters (with the
	exception of Entry Number):
	Entry Number
	Range:	1 to 8
	Default:	1
	Description:	Identifies the particular PAD Prompt Table entry being configured
		by the other parameter in the record. This parameter is not config-
		urable.

PAD Prompt Text

Range:	0 to 1023 alphanumeric characters
Default:	N/A
Description:	This text appears in place of the default PAD prompt asterisk (*).
	Enter the PAD prompt as a series of ASCII characters, terminated
	by a <CR>.
	Use these special characters to display information about the PAD
	Prompt text. If the character following the (%) symbol is not a
	special character, both the (%) and these character are discarded.
	• A: Node address
	• C: Channel number
	• G: Group subaddress
	• N: Node name
	• P: Port number
	• S: Subaddress
	• T: Time
	• V: Software revision
	Enter the caret (^^) twice (it is discarded otherwise) as an escape
	character to tell the PAD to send control characters. The character
	following the caret is converted to a control character and is sent
	to the PAD port for output.

26 Configuring PAD/ATPAD Ports