3Com S200 manual Copying PAD Profile Tables into a Configuration, Size, Select Copy/Insert Record

PAD Profile Table Record

Copying PAD Profile Tables into a Configuration

Introduction	Each node processor card contains 14 PAD Profiles stored in memory.
	By using the parameter values in the stored PAD Profile Table, you can copy them
	into the configuration memory as if you had entered the parameter values one
	parameter at a time.
	The PAD accepts identifiers from 0 to 99. The profiles from 0 to 12, 90, and 91 are
	listed in this section. All the remaining profiles (0, 14-89, and 92-99) are DEFAULT
	as existing now.
PAD Profile Table
	The Size of the PAD Profile Table has increased to 100 so that Entry Number 1 under
Size	PAD Profile Table configuration corresponds to Profile Identifier 0, Entry Number 2
	to Profile Identifier 1, and so on. Entry Number 100 corresponds to Profile Identifier
	99.
		Note
		You cannot enter 0 as an Entry Number.

Copying a PAD Follow these steps to copy any of these PAD Profile Tables into your configuration:

Profile Table

Step	Action	Result
1	Select Copy/Insert Record ->	This prompt appears:
	Copy Special PAD Profile	From Entry Number: 1/
	from PROM from the CTP Main
	menu.	Select the PAD Profile Table you
		want to copy into your
		configuration.
2	Type the entry number followed by	You are then prompted for the next
	<CR>.	Entry Number (or just press <CR>).
		This allows you to configure more
		than one entry with the same stored
		PAD Profile Table.
		The parameter values in the stored
		PAD Profile Table are copied into
		the configuration memory (as if
		you had entered the parameter
		values one parameter at a time).
3	Press <ESC> once you are	The Copy/Insert Record menu
	finished.	reappears.

44 Configuring PAD/ATPAD Ports