3Com S200 manual Configuration, Use these guidelines when you enter ATPAD commands, Guidelines

ATPAD Ports

Configuration

Guidelines Use these guidelines when you enter ATPAD commands:

•Type the commands in upper, lower, or mixed case. If echo is enabled, the commands are echoed in all capitals.

•Use white space (TAB and SPACE) characters anywhere on the command line. The command processor ignores them.

•Edit the buffer using the configurable Back Space Character.

•Be sure that you do not exceed the buffer's maximum length. Otherwise, you get the result code ERROR.

•Type AT<CR> to clear the command buffer.

•Be aware that you can:

–Enter commands that are not supported by the ATPAD. You get the result code OK, but the ATPAD does not act on the unsupported commands.

–Enter multiple commands on a single command line. However, the ATPAD recognizes only the first supported command.

Configuring The You can configure the ATPAD port using the CTP by selecting the Port item under

ATPADthe Configure menu. You can perform these standard Port Control functions using the CTP:

•Port Boot

•Port Enable

•Port Disable

•Port Busy-out

Configuring PAD/ATPAD Ports 61