3Com S200 manual Remote PAD Parameter Table Record, What You See In, Select Remote PAD Parameter

Remote PAD Parameter Table Record

Remote PAD Parameter Table Record

Introduction	This record contains parameters that define a specified remote PAD. When a call is
	made to a port that uses this table entry, an X.29 set command is sent.
What You See In
	Figure 8 shows how the Remote PAD Parameter Table Record and its configuration
This Record	parameters fit into the PathBuilder S200 series switch menu hierarchy.
	Node:	Address:	Date:	Time:
	Menu: Configure	Path: (Main.6)

Node

Port

•

•

•

Remote Parameter Table

Before You Begin

Configuration Guidelines

Accessing the

Remote PAD

Parameter Table

Record

Entry Number

Parameter Number

Parameter Value

Figure 8. Remote PAD Parameter Table Record

Before you can configure parameters, you must log on to the local node’s control terminal port. Refer to the Configuration Basics Guide for CTP procedures.

When you configure the Remote PAD Parameter Table Record, do not use duplicate Parameter Numbers.

Follow these steps to access the Remote PAD Parameter Table record:

Step	Action	Result
1	Select Configure from the CTP	The Configure menu appears.
	Main menu.
2	Select Remote PAD Parameter	The Remote PAD Parameter Table
	Table from the Configure menu.	and its parameters appear.
		A prompt appears asking you to
		configure the next parameter.
3	Enter the parameter values.
4	Press <ESC> to return to the
	Configure menu after you have
	configured all parameters.

Configuring PAD/ATPAD Ports 49