Figure 11. Removing the Hard Disk Tray

Reassembly Notes Screws,

M2.5x4mm (2)

Screws,

M2.5x4mm (2)

Figure 11. Removing the Hard Disk Tray

Reassembly Notes

Insert the connector end of the drive through the opening in the tray, then lower the drive into place.

Carefully slide the hard drive assembly into its compartment. Press firmly to make sure the connector seats properly.

Important

If you are installing a new hard disk drive, install the factory software and operating system on the drive before loading any additional software—see “Recovering the Factory Software Installation” on page 37.

zt1100/xz200 and xt1500 Series

Removing and Replacing Parts

43

Troubleshooting and Self-Repair Guide

 

 

Page 43
Image 43
3D Connexion XZ200, ZT1000, XT1500 manual Removing the Hard Disk Tray, Reassembly Notes