gis
10 Shutting down
10.1Introduction
This chapter describes:
•Shut the appliance down for a brief period ("OFF mode");
•Electrically isolating the appliance;
•Shutting the appliance down for a long period.
10.2Shut the appliance down for a brief period ("OFF mode")
To shut the appliance down for a brief period, you must activate the frost protection.
You can use the frost protection to prevent water freezing in the appliance.
Activate the frost protection as follows:
1.Press the 
button to select the main menu.
2.Use 
and 
to position the cursor in front of OFF.
Confirm with 
.
OFF
13:45 Thursday 6ÉC
FROST PROTECTION ACTIVATED
The frost protection cuts in if the water temperature drops below 5°C. The text FROST will then appear on line one of the display. The appliance heats the water to 20°C (Tset) and drops back to the OFF mode.
Note
These values of 5°C and 20°C cannot be adjusted.
4.Wait until the fan has stopped. The 
symbol is then dimmed.
5.Switch the appliance OFF (position 0) using the ON/OFF switch on the control panel.
6.Isolate the appliance from the power supply by setting the isolator between the appliance and the mains power supply to position 0.
10.4Shutting the appliance down for a long period
Drain the appliance if you are shutting it down for a long period. Proceed as follows:
1.Isolate the appliance from the power
supply (10.3 "Electrically isolating the appliance").
2.Shut off the gas supply.
3.Close the stop valve in the hot water pipe.
4.Open the drain valve
5.Bleed the appliance (or installation) so that it drains completely.
10.3 Electrically isolating the appliance
The appliance should only be isolated from mains power in the correct way. The correct procedure is as follows:
1.Activate the MENU with 
.
2.Position the cursor in front of OFF.
3.Confirm OFF with 
.
MENU »OFF ^ ON
È WEEK PROGRAM
Caution
Failure to wait until the fan stops purging can cause damage to the appliance.
Instruction manual SGE | 63 |
