ADC HDSL4 Testing with H4TU-C Bert Generator, Option Description, Bert Signal Generator

Testing LTPH-UM-1031-03, Issue 3

TESTING WITH H4TU-C BERT GENERATOR

The H4TU-C BERT Generator screen allows transmission of an unframed test signal from the H4TU-C toward either the CI or the network.

It is not recommended using the Bit Error Rate Tester from the remote and line unit at the same time.

1Press C to select the Config menu (Figure 30).

2Use the ↑ and ↓ arrow keys to select BERT Generator, then press ENTER .

3Use the arrow keys to select an option and press the SPACEBAR to cycle through the settings. Refer to Table 19 for a list of BERT generator option settings.

4Press ENTER to activate your choice.

5To view BERT status, press ESC twice, then use the ← arrow key to select the Monitor menu.

6Press ENTER . You can exit the status screen while signal generation is active.

Monitor	Performance Event Log		Config	Inventory	Report Rlogon		Help
	----------------------+					+
		Standard Options			->
			ADC Options		->
			BERT Generator		->

+--------------------------------------			+
BERT Signal Generator	:	ENA
BERT Signal Pattern	:	1 in 8
BERT Signal Linecode	: AMI
BERT Signal Direction	: NET only
BERT Interval	: Continuous
+--------------------------------------			+

Use <Spacebar> to cycle through option settings and				<Enter> to activate
ID: xxxx—-xxxx—-xxxx--xxxx			02/01/2002 12:30:01	H4TU-C	System:	OK___
	Figure 30. H4TU-C BERT Generator Screen
	Table 19. BERT Signal Generator Option Settings
	Option	Description
	BERT Signal Generator	Enabled (ENA) or Disabled (DIS)
	BERT Signal Pattern	1-in-8 pattern, 2-in-8 pattern, 3-in-24 pattern, 223-1pseudo random,
		220-1pseudo random, 215-1pseudo random
	BERT Signal Linecode	AMI or B8ZS
	BERT Signal Direction	Toward CPE or toward NET
	BERT Interval	5 minutes, 60 minutes, Continuous (default)

56 September 12, 2003 H4TU-C-319 List 1