Configuring the IPR-S1000
abort
Allows to abort modifications after one or many set command.
auth (Authentication)
Allows to change the authentication level, i.e to switch to the public, read or write level. A password is needed only when switching to a more restricted level.
read: Allows to read the whole
write: Allows a complete configuration access, and allows to change the set up parameters.
bye
Allows to exit the shell.
default + name of the profile that will become the starting profile Allows to make a profile the startup profile.
defaultfactory
Allows to make the factory profile the startup profile.
delete + name of the profile to be removed
Allows to remove a profile.
dvb (Digital Video Broadcast)
Real-time access to the DVB interface.
dlevel: Digital level in percent.
fec: Current FEC, useful if FEC auto is enabled.
lock: Yes if locked, No otherwise.
macaddress: MAC address of this interface (it cannot be modified).
macaddresses: List of all MAC addresses currently treated by the receiver card.
mpebytes: Amount of bytes received at MPE level on the satellite interface.
mpepackets: Amount of IP packets received through MPE on the satellite interface.
sn: Eb/No. Signal noise ratio in dB.
temp: The temperature (given in celcius degree) of the warmest point to be found in the equipment.
uncor.: Total number of packets that could not be corrected by the demodulator.
vber: Rate of erroneous bits before Read Salomon (for example, a VBER of
dvbdump
Table dump.
77
