Configuring the IPR-S1000
fec: current FEC, useful if FEC auto is enabled.
lock: Yes if locked, No else.
macaddress: MAC address of this interface (it cannot be modified).
macaddresses: List of all MAC addresses currently treated by the receiver card.
mpebytes: Amount of bytes received at MPE level on the satellite interface.
mpepackets: Amount of IP packets received through MPE on the satellite interface.
sn: Eb/No. Signal noise ratio in dB.
temp: The temperature (given in celcius degree) of the warmest point to be found in the equipment.
uncor.: Amount of received packets that have not been corrected since the last unlocking (up to 127).
vber: Rate of erroneous bits before Read Salomon (for example, a VBER of
dvbdump
Table dump.
bat: bouquet association table.
cat: conditional access table.
eit: event information table.
nit: network information table.
pat: program association table.
pid_revealer: gives the type of flow.
pmt_pid: program map table.
rst: running status table.
sdt: service description table.
tdt: time and date table.
tot: time offset table.
exit
Allows to exit the shell.
get
Asks for the attribute value of the section.attribut. Pressing Tab after «get» will display all the available attributes (see part C: sections and attributes). They will be summed up in the next section. getdefault
Allows to know the name of the starting profile. If nothing is displayed, it means it is the factory profile.
help
Displays helpful information about commands.
83
