Agilent Technologies Agilent E6474A manual Setting an iDEN phone’s baud rate

Get Assistance, if You Need It 6

•If you have a Sagem phone that is capable of operating in Data mode, refer to “Changing a Sagem phone’s operating mode" on page 103.

•In the System Setup view, right-click another COM port, then select the Refresh Port command.

•Use a systematic approach to isolate a hardware problem. If available, replace a suspected defective device or cable with a known working device or cable. Replace only one component at a time, then retest.

Setting an iDEN phone’s baud rate

The baud rate for any iDEN phone must be set to 19200 baud, otherwise the phone may not be identified. The following is the procedure for the i1000 Plus phone.

1Power up the phone. Wait for “Phone Ready” to be displayed.

2Press the Menu key 3 times.

3Press the key under Prgm shown in the display. The Programming Menu is displayed.

4Press the key under OK in the display.

5Press the right arrow key until Set Baud Rate: <value> is displayed.

6Press the key under OK in the display.

7Press the right arrow key until 19200 is displayed.

8Press the key under OK in the display.

9Press the key under Exit in the display.

Changing a Sagem phone’s operating mode

The Sagem OT-55P phone can operate in either of two modes, Trace or Data. A communication error may occur if the wrong mode is selected. If you are making parameter measurements, it must be set to Trace mode.

Refer to the phone manufacturers instructions for details on how to change the phone mode settings.

Agilent E6474A User’s Guide 103