Agilent Technologies Agilent E6474A manual Dual receiver backpack final assembly

Set Up Your System 3

4Connect the short RX Loop cable (E7450-60001) to the RX LOOP IN port of Receiver 1.

5Connect the opposite end of the cable to the RX LOOP OUT port of Receiver 2.

6Connect the long RX Loop cable (E7450-60002) to the RX LOOP IN port of Receiver 2.

7Connect the opposite end of the cable to the RX LOOP OUT port of Receiver 1.

8Connect the receiver antennas to the RF INPUT connectors of the receivers.

9If equipped, connect the GPS antennas to the GPS ANTENNA connectors of the receivers.

Dual receiver backpack final assembly

1Place the component platform inside the backpack, as shown in Figure 34 on page 68. It attaches to the backpack with Velcro fasteners.

2Connect one phone interface cable to the (Phone 1) port of the Direct Connect Hub.

3Connect the second phone interface cable to the (Phone 2) port of the Direct Connect Hub.

4Connect the headset cables (E6473-60017) to the connectors of the Direct Connect Hub.

5Attach the clip-on receiver antennas to the antenna loops on the sides of the backpack. See Figure 35.

Agilent E6474A User’s Guide 69