State Activity | Allied Telesis AT-IFS802SP instruction

AT-IFS802SP-80 User Manual

47

6.15.3 State Activity

Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure the state activity for the members of the LACP trunk group.You can tick or cancel the checkbox beside the state label. When you remove the tick mark of the port and click Apply , the port state activity will change to Passive.

•Active:The port automatically sends LACP protocol packets.

•Passive:The port does not automatically send LACP protocol packets, and responds only if it receives LACP protocol packets from the opposite device.

[note]

A link having two passive LACP nodes will not perform dynamic LACP trunk because both ports are waiting for an LACP protocol packet from the opposite device.

State Activity of Switch 1

State Activity of Switch 2

Image 51

Allied Telesis AT-IFS802SP manual State Activity

Contents

AT-IFS802SP Installation and User’s Guide Page Electrical Safety and Emissions Standards Page Preface Preface Content 21.3 Appendix B-Command SetsPage Introduction Hardware Features CSMA/CD Snmp MIB Software Features Package Contents Physical Dimension Hardware DescriptionFront Panel Top View LED LED Indicators Installation Steps Hardware Installation DIN-Rail Mounting Wall Mount Plate Mounting Wiring the Power Inputs Wiring the Fault Alarm Contact Gigabit Copper/SFP SFP combo port CablingPage Ring Application Network Application Coupling Ring Application Dual Homing Application Connecting to the Console Port Console ManagementPin Assignment CLI Management Login in the Console Interface Exec Commands Level Preparing for Web Management System LoginWeb-Based Management About Web-based Management System Information IP Configuration Dhcp Server System configuration Port and IP Bindings Client Entries Update Firmware Restore ConfigurationTftp Backup Configuration Syslog ConfigurationSystem Event Log System Event Log-SMTP Configuration System Event Log Event Configuration Event Configuration interface Sntp Configuration Fault Relay AlarmPage Page IP Security Port Statistics User Authentication Port Control Port Trunk Aggregator setting State Activity tab Aggregator Information Lacp disabled Lacp enabled Page State Activity Port Mirroring Rate Limiting Port-based Vlan Vlan configuration Vlan Port Based interface 18.2 802.1Q Vlan 802.1Q Configuration Page Rapid Spanning Tree Rstp System Configuration Port Configuration Snmp Configuration Trap Configuration SNMPV3 Configuration QoS Policy and Priority Type QoS Configuration Port-based Priority Igmp Configuration COS ConfigurationTOS Configuration Ring Page Security-802.1X/Radius Configuration Lldp Configuration 802.1x System Configuration interface Misc Configuration MAC Address TableStatic MAC Address MAC Filtering MAC Address Table-Multicast Filtering All MAC Addresses Multicast Filtering interface Factory Default Save ConfigurationSystem Reboot Troubles shooting RJ-45 Pin Assignments Appendix A-RJ-45 Pin Assignment 10/100/1000Base-TX Pin outs 10/100/1000Base-TX Cable Schematic System Commands Set Appendix B-Command Sets Subnet mask PasswordLow IP High IP 101001000auto Port Commands SetPortid Duplex full half Disable State Enable Trunk Commands Set Vlan Commands Set Vlan 8021q trunk Time seconds Spanning Tree Commands Set~61440 Seconds Port Priority AutoTrueFalseTrueFalse Commands Set Show igmp Igmp enableIgmp-query auto Igmp-query force Show mac-address Mac-address-tableStatic hwaddr Filter hwaddr Community-string Authentication Password PrivacyV1v2cv3v1v2cv3 Strings Community View Name ExcludedIncludedHost-address RXTXBoth Port ID WordsSec Accept authorize Disable reject Flashrestorecfg BackupFlashbackupcfg Restore SystemLog, Smtp and Event Commands Set Change No event authenticationFailure No event ring-topology Timezone Sntp Commands SetStart time End time Minute Ring Commands Set Control PortDual Homing Port