Allied Telesis AT-WR4500 manual Define new Ospf area named local10 with area-id, Name AREA-ID Stub

AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers						105
RouterOS v3 Configuration and User Guide
	Now let's setup the OSPF_MAIN router.
	The router should have 3 NICs:
	[admin@OSPF_MAIN] interface> print
	Flags: X - disabled, D - dynamic, R - running
	#	NAME		TYPE	RX-RATE	TX-
	RATE	MTU
	0	R main_gw		ether	0	0
	1500
	1	R to_peer_1		ether	0	0
	1500
	2	R to_peer_2		ether	0	0
	1500
	Add all needed ip addresses to interfaces as it is shown here:
	[admin@OSPF_MAIN] ip address> print
	Flags: X - disabled, I - invalid, D - dynamic
	#	ADDRESS	NETWORK	BROADCAST	INTERFACE
	0	192.168.0.11/24	192.168.0.0	192.168.0.255	main_gw
	1	10.1.0.2/24	10.1.0.0	10.1.0.255	to_peer_1
	2	10.2.0.2/24	10.2.0.0	10.2.0.255	to_peer_2

You should set distribute-default as if-installed-as-type-2, redistribute-connected as as-type-1 and redistribute-static as as-type-2. Metric-connected, metric-static, metric-rip, metric-bgp should be zero

[admin@OSPF_MAIN] routing ospf> print router-id: 0.0.0.0

distribute-default: if-installed-as-type-2 redistribute-connected: as-type-1

redistribute-static: as-type-2 redistribute-rip: no redistribute-bgp: no

metric-default: 1 metric-connected: 0 metric-static: 0 metric-rip: 0 metric-bgp: 0

Define new OSPF area named local_10 with area-id 0.0.0.1:

[admin@OSPF_MAIN] routing ospf area> print
Flags: X - disabled, I - invalid
#	NAME	AREA-ID	STUB	DEFAULT-COST
AUTHENTICATION
0	backbone			0.0.0.0
none
1	local_10	0.0.0.1	no	1
none

Add connected networks with area local_10 in ospf network:

[admin@OSPF_MAIN] routing ospf network> print Flags: X - disabled, I - invalid

#	NETWORK	AREA
0	10.1.0.0/24	local_10
1	10.2.0.0/24	local_10

For main router the configuration is done. Next, you should configure OSPF_peer_1 router. Enable followong interfaces on OSPF_peer_1:

[admin@OSPF_peer_1] interface> print
Flags: X - disabled, D - dynamic, R - running
#		NAME	TYPE	RX-RATE	TX-RATE	MTU
0	R	backup	ether	0	0	1500
1	R	to_main	ether	0	0	1500