Allied Telesis AT-WR4500 manual Set wds-default-bridge to bridge1

AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers	63
RouterOS v3 Configuration and User Guide

•Configure AP to support WDS connections

•Set wds-default-bridge to bridge1

•On WDS station:

•Configure it as a WDS Station, using mode=station-wds

•

Configure the WDS Access Point. Configure the wireless interface and put it into a bridge, and define that the dynamic WDS links should be automatically put into the same bridge:

[admin@WDS_AP] > interface bridge

[admin@WDS_AP] interface bridge> add

[admin@WDS_AP] interface bridge> print Flags: X - disabled, R - running

0R name="bridge1" mtu=1500 arp=enabled mac-address=B0:62:0D:08:FF:FF stp=no priority=32768 ageing-time=5m forward-delay=15s

garbage-collection-interval=4s hello-time=2s max-message-age=20s [admin@WDS_AP] interface bridge> port

[admin@WDS_AP] interface bridge port> add interface=ether1 bridge=bridge1

[admin@WDS_AP] interface bridge port> /interface wireless

[admin@WDS_AP] interface wireless> set wlan1 mode=ap-bridge ssid=wds-sta-test \

wds-mode=dynamic wds-default-bridge=bridge1 disabled=no band=2.4ghz-b/g \ frequency=2437

[admin@WDS_AP] interface wireless> print Flags: X - disabled, R - running

0name="wlan1" mtu=1500 mac-address=00:0C:42:05:00:22 arp=enabled disable-running-check=no interface-type=Atheros AR5413 radio-name="000C42050022" mode=ap-bridge ssid="wds-sta-test" area="" frequency-mode=superchannel country=no_country_set antenna-gain=0 frequency=2437 band=2.4ghz-b/g scan-list=default rate-set=default supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps

supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps, 54Mbps

basic-rates-b=1Mbps basic-rates-a/g=6Mbps max-station-count=2007 ack-timeout=dynamic tx-power=default tx-power-mode=default noise-floor-threshold=default periodic-calibration=default burst-time=disabled fast-frames=no dfs-mode=none antenna-mode=ant-a wds-mode=dynamic wds-default-bridge=bridge1 wds-ignore-ssid=no update-stats-interval=disabled default-authentication=yes default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0 hide-ssid=no security-profile=default disconnect-timeout=3s on-fail-retry-time=100ms preamble-mode=both