Allied Telesis AT-WR4500 manual

142	AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
	RouterOS v3 Configuration and User Guide

default - derive this value from the interface default profile; same as no if this is the interface default profile

dns-server(IP address{1,2}) - IP address of the DNS server to supply to clients

idle-timeout(time) - specifies the amount of time after which the link will be terminated if there was no activity present. There is no timeout set by default

0s - no link timeout is set

incoming-filter(name) - firewall chain name for incoming packets. Specified chain gets control for each packet coming from the client. The ppp chain should be manually added and rules with action=jump jump-target=pppshould be added to other relevant chains in order for this feature to work. For more information look at the Examples section

local-address(IP address name) - IP address or IP address pool name for PPP server name (name) - PPP profile name

only-one(yes no default; default: default) - defines whether a user is allowed to have more then one connection at a time

yes - a user is not allowed to have more than one connection at a time no - the user is allowed to have more than one connection at a time

default - derive this value from the interface default profile; same as no if this is the interface default profile

outgoing-filter(name) - firewall chain name for outgoing packets. Specified chain gets control for each packet going to the client. The ppp chain should be manually added and rules with action=jump jump- target=ppp should be added to other relevant chains in order for this feature to work. For more information look at the Examples section

rate-limit (text; default: "") - rate limitation in form of rx-rate[/tx-rate] [rx-burst-rate[/tx-burst- rate] [rx-burst-threshold[/tx-burst-threshold] [rx-burst-time[/tx-burst-time] [priority] [rx- rate-min[/tx-rate-min]]]] from the point of view of the router (so "rx" is client upload, and "tx" is client download). All rates are measured in bits per second, unless followed by optional 'k' suffix (kilobits per second) or 'M' suffix (megabits per second). If tx-rate is not specified, rx-rate serves as tx-rate too. The same applies for tx-burst-rate,tx-burst-threshold and tx-burst-time. If both rx-burst-threshold and tx-burst-threshold are not specified (but burst-rate is specified), rx-rate and tx-rate are used as burst thresholds. If both rx-burst-time and tx-burst-time are not specified, 1s is used as default. Priority takes values 1..8, where 1 implies the highest priority, but 8 - the lowest. If rx-rate-min and tx-rate-min are not specified rx-rate and tx-rate values are used. The rx-rate-min and tx-rate-min values can not exceed rx- rate and tx-rate values.

remote-address(IP address name) - IP address or IP address pool name for PPP clients session-timeout(time) - maximum time the connection can stay up. By default no time limit is set 0s - no connection timeout

use-compression(yes no default; default: default) - specifies whether to use data compression or not

yes - enable data compression no - disable data compression

default - derive this value from the interface default profile; same as no if this is the interface default profile

use-encryption(yes no required default; default: default) - specifies whether to use data encryption or not

yes - enable data encryption no - disable data encryption requided - enable and require encryption

default - derive this value from the interface default profile; same as no if this is the interface default profile

use-vj-compression(yes no default; default: default) - specifies whether to use Van Jacobson header compression algorithm

yes - enable Van Jacobson header compression no - disable Van Jacobson header compression

default - derive this value from the interface default profile; same as no if this is the interface default profile

wins-server(IP address{1,2}) - IP address of the WINS server to supply to Windows clients