Allied Telesis AT-WR4500 manual Nstreme network example

66	AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
	RouterOS v3 Configuration and User Guide

Nstreme

This example shows you how to configure a point-to-point Nstreme link.

Nstreme 2

Nstreme 1

Figure 7: Nstreme network example

The setup of Nstreme is similar to usual wireless configuration, except that you have to do some changes under /interface wireless nstreme.

Set the Nstreme-APto bridge mode and enable Nstreme on it:

[admin@Nstreme-AP] interface wireless> set 0 mode=bridge ssid=nstreme \ \... band=5ghz frequency=5805 disabled=no

[admin@Nstreme-AP] interface wireless> print Flags: X - disabled, R - running

0name="wlan1" mtu=1500 mac-address=00:0C:42:05:00:22 arp=enabled disable-running-check=no interface-type=Atheros AR5413 radio-name="000C42050022" mode=bridge ssid="nstreme" area="" frequency-mode=superchannel country=no_country_set antenna-gain=0 frequency=5805 band=5ghz scan-list=default rate-set=default supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps

supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps, 54Mbps

basic-rates-b=1Mbps basic-rates-a/g=6Mbps max-station-count=2007 ack-timeout=dynamic tx-power=default tx-power-mode=default noise-floor-threshold=default periodic-calibration=default burst-time=disabled fast-frames=no dfs-mode=none antenna-mode=ant-a wds-mode=disabled wds-default-bridge=none wds-ignore-ssid=no update-stats-interval=disabled default-authentication=yes default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0 hide-ssid=no security-profile=default disconnect-timeout=3s on-fail-retry-time=100ms preamble-mode=both

[admin@Nstreme-AP] interface wireless> nstreme

[admin@Nstreme-AP] interface wireless nstreme> set wlan1 enable-nstreme=yes

[admin@Nstreme-AP] interface wireless nstreme> print

0 name="wlan1" enable-nstreme=yes enable-polling=yes framer-policy=none framer-limit=3200

[admin@Nstreme-AP] interface wireless nstreme>