AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers

53

RouterOS v3 Configuration and User Guide

 

 

 

audio-min(integer; default: -100) - signal-strength at which audio (beeper) frequency will be the lowest

audio-monitor(MAC address; default: 00:00:00:00:00:00) - MAC address of the remote host which will be 'listened'

filter-mac(MAC address; default: 00:00:00:00:00:00) - in case if you want to receive packets from only one remote host, you should specify here its MAC address

frame-size(integer: 200..1500; default: 300) - size of 'alignment' packets that will be transmitted

frames-per-second(integer: 1..100; default: 25) - number of frames that will be sent per second (in active-mode)

receive-all(yes no; default: no) - whether the interface gathers packets about other 802.11 standard packets or it will gather only 'alignment' packets

ssid-all(yes no; default: no) - whether you want to accept packets from hosts with other ssid than yours

Command Description

test-audio(integer) - test the beeper for 10 seconds

￿

If you are using the command /interface wireless align monitor then it will automatically change the wireless interface's mode from station, bridge or ap-bridge to alignment-only.

Example

[admin@AT-WR4562] interface wireless align> print frame-size: 300

active-mode: yes

receive-all: yes audio-monitor: 00:00:00:00:00:00

filter-mac: 00:00:00:00:00:00 ssid-all: no

frames-per-second: 25 audio-min: -100 audio-max: -20

[admin@AT-WR4562] interface wireless align>

4.3.12Align Monitor

Command name: /interface wireless align monitor

Description

This command is used to monitor current signal parameters to/from a remote host.

Property Description

address (read-only: MAC address) - MAC address of the remote host

avg-rxq(read-only: integer) - average signal strength of received packets since last display update on screen

correct (read-only: percentage) - how many undamaged packets were received

last-rx(read-only: time) - time in seconds before the last packet was received

last-tx(read-only: time) - time in seconds when the last TXQ info was received

rxq (read-only: integer) - signal strength of last received packet

ssid (read-only: text) - service set identifier

txq (read-only: integer) - the last received signal strength from our host to the remote one

Page 53
Image 53
Allied Telesis AT-WR4500 manual Align Monitor, Command name /interface wireless align monitor