Allied Telesis AT-WR4500 manual Monitoring Pptp Client, Pptp Server Setup

AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers	181
RouterOS v3 Configuration and User Guide

8.7.3 Monitoring PPTP Client

Command name: /interface pptp-client monitor

Property Description

encoding (text) - encryption and encoding (if asymmetric, separated with '/') being used in this connection

idle-time(read-only: time) - time since the last packet has been transmitted over this link

mru (read-only: integer) - effective MRU of the link

mtu (read-only: integer) - effective MTU of the link status (text) - status of the client

dialing - attempting to make a connection

verifying password... - connection has been established to the server, password verification in progress connected - self-explanatory

terminated - interface is not enabled or the other side will not establish a connection uptime (time) - connection time displayed in days, hours, minutes and seconds

Example

Example of an established connection:

[admin@AT-WR4562] interface pptp-client> monitor test2 status: "connected"

uptime: 6h44m9s idle-time: 6h44m9s encoding: "MPPE128 stateless"

mtu: 1460

mru: 1460

[admin@AT-WR4562] interface pptp-client>

8.7.4 PPTP Server Setup

Submenu level: /interface pptp-server server

Description

The PPTP server creates a dynamic interface for each connected PPTP client. The PPTP connection count from clients depends on the license level you have. Level1 license allows 1 PPTP client, Level3 or Level4 licenses up to 200 clients, and Level5 or Level6 licenses do not have PPTP client limitations.

Property Description

authentication (multiple choice: pap chap mschap1 mschap2; default: mschap2) - authentication algorithm

default-profile- default profile to use

enabled (yes no; default: no) - defines whether PPTP server is enabled or not

keepalive-timeout(time; default: 30) - defines the time period (in seconds) after which the router is starting to send keepalive packets every second. If no traffic and no keepalive responses has came for that period of time (i.e. 2 * keepalive-timeout), not responding client is proclaimed disconnected max-mru(integer; default: 1460) - Maximum Receive Unit. The optimal value is the MRU of the interface the tunnel is working over decreased by 40 (so, for 1500-byte ethernet link, set the MRU to 1460 to avoid fragmentation of packets)

max-mtu(integer; default: 1460) - Maximum Transmission Unit. The optimal value is the MTU of the interface the tunnel is working over decreased by 40 (so, for 1500-byte ethernet link, set the MTU to 1460 to avoid fragmentation of packets)

mrru (integer: 512..65535; default: disabled) - maximum packet size that can be received on the link. If a packet is bigger than tunnel MTU, it will be split into multiple packets, allowing full size IP or Ethernet packets to be sent over the tunnel

disabled - disable MRRU on this link