Allied Telesis AT-WR4500 manual Nstreme Settings, To see current interface settings, Last-ip

40	AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
	RouterOS v3 Configuration and User Guide

To see current interface settings:

[admin@AT-WR4562] interface wireless> print Flags: X - disabled, R - running

Flags: X - disabled, R - running

0name="wlan1" mtu=1500 mac-address=00:0C:42:18:5C:3D arp=enabled interface-type=Atheros AR5413 mode=station ssid="AT-WR4560" frequency=2412 band=2.4ghz-b scan-list=default antenna-mode=ant-a wds-mode=disabled wds-default-bridge=none wds-ignore-ssid=no default-authentication=yes default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0

hide-ssid=no security-profile=default compression=no [admin@AT-WR4562] interface wireless>

Set the ssid to mmt, band to 2.4-b/g and enable the interface. Use the monitor command to see the connection status.

[admin@AT-WR4562] interface wireless> set 0 ssid=mmt disabled=no band=2.4ghz-b/g

[admin@AT-WR4562] interface wireless> monitor wlan1 status: connected-to-ess

band: 2.4ghz-g frequency: 2412MHz tx-rate: "54Mbps" rx-rate: "54Mbps"

ssid: "mmt"

bssid: 00:0C:42:05:00:14 radio-name: "000C42050014"

signal-strength: -23dBm tx-signal-strength: -35dBm noise-floor: -96dBm

signal-to-noise: 73dB tx-ccq: 79% rx-ccq: 46% p-throughput: 28681

overall-tx-ccq: 79% authenticated-clients: 1

current-ack-timeout: 56 wds-link: no nstreme: no

framing-mode: none routeros-version: "3.0"

last-ip: 10.10.10.1

802.1x-port-enabled: yes compression: no

current-tx-powers: 1Mbps:19(19),2Mbps:19(19),5.5Mbps:19(19), 11Mbps:19(19),6Mbps:19(19),9Mbps:19(19), 12Mbps:19(19),18Mbps:19(19),24Mbps:19(19), 36Mbps:18(18),48Mbps:17(17),54Mbps:16(16)

notify-external-fdb: no [admin@AT-WR4562] interface wireless>

The 'ess' stands for Extended Service Set (IEEE 802.11 wireless networking).

4.3.3 Nstreme Settings

Submenu level: /interface wireless nstreme

Description

You can switch a wireless card to the nstreme mode. In that case the card will work only with nstreme clients.

Property Description

disable-csma(yes no; default: no) - disable CSMA/CA when polling is used (better performance) enable-nstreme(yes no; default: no) - whether to switch the card into the nstreme mode enable-polling(yes no; default: yes) - whether to use polling for clients

framer-limit(integer; default: 3200) - maximal frame size

framer-policy(none best-fit exact-size dynamic-size; default: none) - the method how to combine frames. A number of frames may be combined into a bigger one to reduce the amount of protocol