Allied Telesis AT-WR4500 manual Add the same area as in main router, Add the needed IP addresses

106			AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
				RouterOS v3 Configuration and User Guide
	Assign IP addresses to these interfaces:
	[admin@OSPF_peer_1] ip address> print
	Flags: X - disabled, I - invalid, D - dynamic
	#	ADDRESS	NETWORK	BROADCAST	INTERFACE
	0	10.1.0.1/24	10.1.0.0	10.1.0.255	to_main
	1	10.3.0.1/24	10.3.0.0	10.3.0.255	backup

Set redistribute-connected as as-type-1. Metric-connected, metric-static, metric-rip, metric-bgp should be zero.

[admin@OSPF_peer_1] routing ospf> print

router-id:	0.0.0.0
distribute-default:	never
redistribute-connected:	as-type-1
redistribute-static:	no
redistribute-rip:	no
redistribute-bgp:	no
metric-default:	1
metric-connected:	0
metric-static:	0
metric-rip:	0
metric-bgp:	0

Add the same area as in main router:

[admin@OSPF_peer_1] routing ospf area> print
Flags: X - disabled, I - invalid
#	NAME	AREA-ID		STUB	DEFAULT-COST
AUTHENTICATION
0	backbone	0.0.0.0			none
1	local_10	0.0.0.1	no	1	none

Add connected networks with area local_10:

[admin@OSPF_peer_1] routing ospf network> print Flags: X - disabled, I - invalid

#	NETWORK	AREA
0	10.3.0.0/24	local_10
1	10.1.0.0/24	local_10

Finally, set up the OSPF_peer_2 router. Enable the following interfaces:

[admin@OSPF_peer_2] interface> print
Flags: X - disabled, D - dynamic, R - running
#	NAME	TYPE	RX-RATE	TX-
RATE	MTU
0	R to_main	ether	0	0
1500
1	R to_peer_1	ether	0	0
1500

Add the needed IP addresses:

[admin@OSPF_peer_2] ip address> print
Flags: X - disabled, I - invalid, D - dynamic
#	ADDRESS	NETWORK	BROADCAST	INTERFACE
0	10.2.0.1/24	10.2.0.0	10.2.0.255	to_main
1	10.3.0.2/24	10.3.0.0	10.3.0.255	to_peer_1