Allied Telesis AT-WR4500 manual Monitoring the Interface Status, Type RX-RATE TX-RATE MTU, Arp

32	AT-WR4500 Series - IEEE 802.11abgh Outdoor Wireless Routers
	RouterOS v3 Configuration and User Guide

default - suport long cables short - support short cables standard - same as default

disable-running-check(yes no; default: yes) - disable running check. If this value is set to 'no', the router automatically detects whether the NIC is connected with a device in the network or not full-duplex(yes no; default: yes) - defines whether the transmission of data appears in two directions simultaneously

mac-address(MAC address) - set the Media Access Control number of the card

mdix-enable(yes no) - whether the MDI/X auto crosscable correction feature is enabled for the port (if applicable)

mtu (integer; default: 1500) - Maximum Transmission Unit

name (name; default: etherN) - assigned interface name, whrere 'N' is the number of the ethernet interface

speed (10 Mbps 100 Mbps 1 Gbps) - sets the data transmission speed of the interface. By default, this value is the maximal data rate supported by the interface

￿

When disable-running-check is set to no, the router automatically detects whether the NIC is connected to a device in the network or not. When the remote device is not connected (the leds are not blinking), the route which is set on the specific interface, becomes invalid.

Command Description

reset-mac(name) - set the MAC address of the NIC to the factory default setting

Example

[admin@AT-WR4562] > interface print
Flags: X - disabled, D - dynamic, R - running
#	NAME	TYPE	RX-RATE	TX-RATE	MTU
0	X ether1	ether	0	0	1500
[admin@AT-WR4562] > interface enable ether1
[admin@AT-WR4562] > interface print
Flags: X - disabled, D - dynamic, R - running
#	NAME	TYPE	RX-RATE	TX-RATE	MTU
0	R ether1	ether	0	0	1500
[admin@AT-WR4562] > interface ethernet
[admin@AT-WR4562] interface ethernet> print
Flags: X - disabled, R - running
#	NAME	MTU	MAC-ADDRESS	ARP
0	R ether1	1500	00:0C:42:03:00:F2 enabled
[admin@AT-WR4562] interface ethernet> print detail
Flags: X - disabled, R - running
0	R name="ether1" mtu=1500 mac-address=00:0C:42:03:00:F2 arp=enabled
	disable-running-check=yes auto-negotiation=yes full-duplex=yes
	cable-settings=default speed=100Mbps

[admin@AT-WR4562] interface ethernet>

4.2.3 Monitoring the Interface Status

Command name: /interface ethernet monitor

Property Description

auto-negotiation(done incomplete) - fast link pulses (FLP) to the adjacent link station to negotiate the SPEED and MODE of the link. Both stations choose the maximal speed boh support.

done - negotiation done incomplete - negotiation failed

default-cable-setting(read-only: short standard) - default cable length setting (only applicable to NS DP83815/6 cards)

short - support short cables standard - same as default