Controller Object Commands

backup the controller cache in the event of power loss), temperature, voltage, readiness, and so forth.

Additional attributes about controllers, units, ports and disks can be obtained by querying for them explicitly. For details, see the other show subcommands.

Typical output looks like:

//localhost> /c2

show

 

Unit UnitType

Status

%RCmpl %V/I/M Stripe Size(GB) Cache AVrfy

---------------------------------------------------------------------------

u0

RAID-5

OK

-

 

-

64K

596.004

ON

OFF

u1

RAID-0

OK

-

 

-

64K

298.002

ON

OFF

u2

SPARE

OK

-

 

-

-

149.042

-

OFF

u3

RAID-1

OK

-

 

-

-

149.001

ON

OFF

Port

Status

 

Unit

Size

 

Blocks

Serial

 

---------------------------------------------------------------

 

p0

OK

 

u0

149.05

GB

312581808

WD-WCANM1771318

p1

OK

 

u0

149.05

GB

312581808

WD-WCANM1757592

p2

OK

 

u0

149.05

GB

312581808

WD-WCANM1782201

p3

OK

 

u0

149.05

GB

312581808

WD-WCANM1753998

p4

OK

 

u2

149.05

GB

312581808

WD-WCANM1766952

p5

OK

 

u3

149.05

GB

312581808

WD-WCANM1882472

p6

OK

 

u0

149.05

GB

312581808

WD-WCANM1883862

p7

OK

 

u3

149.05

GB

312581808

WD-WCANM1778008

p8

OK

 

-

149.05

GB

312581808

WD-WCANM1770998

p9

NOT-PRESENT

-

-

GB

-

-

 

 

p10

OK

 

u1

149.05

312581808

WD-WCANM1869003

p11

OK

 

u1

149.05

GB

312581808

WD-WCANM1762464

Name

OnlineState

BBUReady Status

Volt

Temp

Hours

LastCapTest

-------------------------------------------------------------------------

bbu On

Yes

OK

OK

OK

241

22-Jun-2004

/cx show attribute [attribute ...]

This command shows the current setting of the specified attributes on the specified controller. One or many attributes can be specified. Specifying an invalid attribute will terminate the loop. Possible attributes are: achip, allunitstatus, autocarve (9000 series), autorebuild (9550SX, 9590SE, and 9650SE only), bios, carvesize (9000 series), driver, drivestatus, exportjbod (9000 series), firmware, memory, model, monitor, numdrives, numports, numunits, ctlbus (9550SX, 9590SE, and 9650SE only), ondegrade (9500S), pcb, pchip, qpolicy, serial, spinup (9000 series), stagger (9000 series), and unitstatus.

Example: To see the driver and firmware installed on controller 0, enter the following:

//localhost> /c0 show driver firmware /c0 Driver Version = 2.x

/c0 Firmware Version = FE9X 3.x

(In the sample output above, “x” will be replaced with the actual version number.)

www.3ware.com

31

Page 37
Image 37
AMCC 9500S, 9550SX, 9590SE, 9650SE manual Cx show attribute attribute