AMCC 9650SE, 9550SX, 9500S Cx/ux show status, Cx/ux show rebuildstatus, Cx/ux show verifystatus

Unit Object Commands

/cx/ux show attribute [attribute ...]

This command shows the current setting of the specified attributes. One or many attributes can be requested. Specifying an invalid attribute will terminate the loop. Possible attributes are: initializestatus, name (9000 series), qpolicy (9550SX, 9590SE, and 9650SE only), rebuildstatus, serial (9000 series), status, storsave (9550SX, 9590SE, and 9650SE only), verifystatus, volumes (9000 series), autoverify (9000 series), cache, ignoreECC (9000 series), and identify (9550SX, 9590SE, and 9650SE only).

/cx/ux show status

This command reports the status of the specified unit.

Possible statuses include: OK, VERIFYING, VERIFY-PAUSED, INITIALIZING, INIT-PAUSED, REBUILDING, REBUILD-PAUSED, DEGRADED, MIGRATING, MIGRATE-PAUSED, RECOVERY, INOPERABLE, and UNKNOWN. (Definitions of the unit statuses are available in the 3ware Serial ATA RAID Controller User Guide.)

Example:

//localhost> /c0/u0 show status /c0/u5 status = OK

/cx/ux show rebuildstatus

This command reports the rebuildstatus (if any) of the specified unit.

Example:

//localhost> /c0/u5 show rebuildstatus

/c0/u5 is not rebuilding, its current state is OK

If the unit is in the process of migrating, the command will return the following:

//localhost> /c0/u5 show rebuildstatus

/c0/u5 is not rebuilding, its current state is MIGRATING

/cx/ux show verifystatus

This command reports the verifystatus (if any) of the specified unit.

Example:

//localhost> /c0/u5 show verifystatus

/c0/u5 is not verifying, its current state is OK

www.3ware.com 61